Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 22 inch full-extension side-mount ball bearing drawer slide from Knape and Vogt's 8400 series, rated 100 lb per pair, with a self-close spring and a hold-in anti-rebound detent built into one unit. The zinc finish is the workhorse standard for side-mount ball bearing slides: functional, corrosion-resistant indoors, and largely invisible once the cabinet is closed.
The 8400BRV combines a self-close spring with a hold-in anti-rebound detent, and understanding both helps set the right expectation. The self-close spring captures the drawer over the last inch of travel and pulls it home — the drawer finishes closing on its own once it enters the capture zone. The hold-in detent then keeps it there, stopping the rebound bounce that can happen when a loaded drawer is pushed shut firmly. These are spring and detent mechanisms, not a damper: the drawer closes positively, not silently. For a damped, noise-free close, look at the soft-close side of the 8400 family. For a drawer that must reliably self-close and stay put — kitchen cabinets without handles, utility rooms, shop drawers, or mobile installs — the BRV combination handles the job well.
Zinc plating over cold-formed steel is the standard protective finish for side-mount ball bearing slides, and that is exactly what the 8400BRV carries. It resists the humidity and mild cleaners typical of kitchen and bath interiors through years of daily cycling. Zinc is not a decorative finish and is not suited to outdoor, wet, or marine environments — these slides belong inside finished cabinetry. The neutral zinc tone sits behind the drawer box out of sight in normal use, so its appearance rarely drives the selection decision.
This slide earns its place in cabinets where drawers need to close on their own and stay closed — without a handle to pull or a soft-close damper to slow things down. Kitchen base cabinets, laundry room drawers, utility storage, and RV or vehicle cabinetry are all natural fits. The 22 inch length suits standard base cabinet runs, and the 100 lb per pair rating handles loaded pots-and-pans drawers, tool drawers, and file-weight contents without strain. In face-frame cabinets, the back end of the slide needs support; add the appropriate KV rear mounting brackets, sold separately, to complete the installation. KV recommends a maximum drawer width of 24 inches for the 8400 series.
No. The self-close spring pulls the drawer shut, but there is no damper to slow or quiet the close. The drawer closes positively under spring tension, not slowly and silently. For a damped close, choose a soft-close slide.
The self-close pulls the drawer shut; the hold-in detent keeps it there. Without the detent, a firmly closed drawer can bounce back slightly open. The BRV suffix indicates both features are present in the same slide.
No. The 8400 series is non-handed — both slides in the pair are identical and fit either side of the drawer.
Build the drawer box 1 inch narrower than the cabinet opening to leave 1/2 inch of clearance per side for each slide.
Yes. Side-mount slides in face-frame cabinets need support at the rear of the cabinet side. Add the matching KV rear mounting brackets, sold separately, to support the back end of the slide.
The zinc 8400BRV is the 8400 series answer to drawers that need to finish closing on their own and stay there — a practical combination for busy kitchens, utility installs, and mobile cabinetry, in a bulk format suited to shops and contractors doing volume work.
Sold In: 10 Set
