Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #5 x 5/8" flat head hinge and drawer slide installation screw is built for mounting European cup hinges, drawer slides, and cabinet hardware to panel and face-frame surfaces. The 5/8" length is sized to seat hardware mounting plates without over-penetrating standard 3/4" cabinet stock.
European cup hinges and drawer slides attach through mounting plates with pre-drilled holes sized for a #5 or #6 screw. The plate holds the hardware in position; the screw's job is to pull that plate firmly against the cabinet panel without punching through the back face. At 5/8", this screw provides enough thread engagement to hold a hinge or slide plate securely in 3/4" plywood, MDF, or particleboard while keeping the tip well clear of the opposite face. It is also the right call when installing hardware on thinner face-frame material, door panel edges, or any surface where a longer screw would risk blowing through.
The flat head seats into the countersunk openings on hinge base plates and drawer slide mounting flanges, sitting flush rather than standing proud of the hardware face. A #2 Phillips bit drives this screw with the bits already on most installers' drivers. Zinc plating provides the corrosion protection needed for dry indoor cabinet environments, where humidity stays controlled and hardware is not exposed to moisture.
Cabinet shops installing European concealed hinges and undermount or side-mount drawer slides go through installation screws in volume. This screw handles the routine work: mounting hinge cups and base plates to frameless cabinet sides, attaching slide mounting clips, and fastening hardware plates to face-frame stiles where a longer screw would be too much. Contractors hanging pre-assembled cabinets on site and finish carpenters doing hardware installs on furniture or built-ins will find the 100-count box a convenient quantity for a day's work or a single project.
Yes. European cup hinge base plates and mounting flanges are typically pre-drilled for a #5 or #6 screw, and the flat head on this screw seats into those countersunk openings cleanly.
For hardware mounting plates, yes. The screw engages enough panel material to hold a hinge or slide plate firmly. For structural joinery or applications that need deeper thread engagement, a longer length would be the better choice.
When driving through the pre-drilled holes in a hinge plate or slide bracket, no separate pilot is needed. The sharp point self-starts in the panel material through the hardware opening.
For typical residential kitchen and bath cabinet interiors in climate-controlled spaces, zinc provides adequate protection. These screws are for indoor use; they are not rated for direct exposure to standing water or exterior environments.
Yes. The flat head and 5/8" length suit both European cup hinge plates and the mounting flanges on side-mount and undermount drawer slides.
A hinge or slide is only as reliable as its fasteners. This Würth #5 x 5/8" installation screw puts a flat head, coarse thread, and sharp point in the right length for the job, so hardware mounts flush, holds firm, and stays in adjustment.
Sold In: 100 Each
