
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
This Würth #8 x 2 inch washer head assembly screw is built for cabinet shops and production woodworkers who drive screws by the thousands. The combination Phillips and square drive, lubricated finish, and turbo thread work together to keep installation moving with minimal resistance and consistent head seating across panel joinery, case assembly, and interior wood connections.
At 2 inches, this screw reaches comfortably through 3/4-inch panel stock and into a second member with enough thread engagement to pull the joint tight. That makes it a natural fit for cabinet box assembly — fastening side panels to tops and bottoms, securing back panels into the cabinet frame, and attaching interior components like drawer-slide support rails. It also works well for shop-built furniture, face-applied panel trim, and any interior wood assembly where 1-1/2 inches falls short but a longer screw would over-penetrate.
The lubricated finish on this screw is a dry-to-the-touch coating applied to the threads and point. It lowers friction throughout the drive stroke, which matters most during high-volume runs where accumulated heat and torque from thousands of fasteners wear bits and strain motors. The turbo thread compounds that benefit: its aggressive, wider-pitch geometry cuts through particleboard, MDF, plywood, and softwood with less resistance than a standard thread form. The sharp point self-starts in those same materials without a pilot, and the washer head with nibs mills its own seat as it comes down, so every head lands flush and even without a separate countersink step. Carbon steel construction is appropriate for interior, dry-environment assembly.
A shop driving hundreds or thousands of screws a day needs a fastener that behaves consistently from the first box to the last. The combo drive on this screw keeps production moving when operators swap between Phillips and square-drive guns without stopping to change setups. The 3000-piece box format suits shops that want to minimize restocking interruptions and maintain a steady supply at the bench or on the assembly table. This screw is for interior work in cabinet manufacturing, furniture production, millwork assembly, and commercial casework where a reliable, fast-driving #8 x 2 inch screw in volume quantity is the spec.
The combo recess accepts both a #2 Phillips and a #2 square bit in the same opening. Either bit works, so you can use whatever is already in your driver without swapping.
No. The washer head sits on the surface rather than recessing into it. The nibs on the underside of the head mill a clean seat as the screw tightens down, so no separate countersink step is needed.
Yes. The turbo thread and sharp point are well matched to particleboard, MDF, and plywood. The wide-pitch turbo thread grips the fiber matrix of engineered panels effectively and drives with less resistance than a standard thread form.
The lubricant reduces friction between the screw and the material through the full drive stroke. In high-volume production, that means less heat, less torque load on the driver motor, and less wear on the bit — which adds up over a long run.
Yes. This screw is designed for interior, dry-environment assembly. It is not rated for exterior exposure or contact with pressure-treated lumber.
The Würth #8 x 2 inch washer head assembly screw pairs the right length for through-panel joinery with a drive, thread, and finish combination that holds up under production-volume demands — so the work stays on schedule from the first joint to the last.
Sold In: 3000 Each