Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #8 x 1-1/2" Washer Head Face Frame and Pocket-Hole Screw is the standard choice for joining 3/4-inch softwood, plywood, and sheet goods in pocket-hole assemblies. The coarse thread, Type 17 Auger point, and washer head work together to pull joints tight cleanly and reliably, whether you are building cabinet boxes, assembling drawer components, or joining softwood panels in a production run.
At 1-1/2 inches, this screw is matched to the most common pocket-hole scenario in a cabinet shop: joining 3/4-inch material face to face or edge to face. That length gives the screw enough thread engagement in the receiving piece to hold under glue-up clamping and assembly stress, without over-penetrating thin panels or punching through the far side. For shops working in softwood pine, maple plywood, or standard melamine-faced particleboard, 1-1/2 inches is the go-to size. Cabinet box sides, bottom panels, stretchers, and drawer parts all fall into this category. Pocket-hole screws for thicker stock or harder species are sized differently, but this is the size that keeps most standard cabinet production moving.
The washer head on this screw seats flat against the pocket wall and distributes clamping force across a wider footprint than a pan head alone. That matters when driving into the angled pocket bore, where uneven pressure from a smaller head can shift the joint before the glue sets. The #2 square drive recess is designed to hold a correctly sized bit firmly in the recess during installation, which makes it easier to drive in tight spaces inside a cabinet carcass or along a face-frame run. Square drive is a standard in cabinet production for exactly this reason.
This is a coarse-thread screw, which makes it the right choice for softwoods, plywood, MDF, melamine particleboard, and other lower-density engineered panels. For those building frameless cabinet boxes from sheet goods or assembling face frames from pine, poplar, or soft maple, this screw covers the core of the work. It is also a practical option for drawer box construction in sheet material and for light furniture joinery where the material is softwood or engineered panel rather than dense hardwood. Shops that need a fine-thread version for hardwood face frames in maple, oak, or cherry should select the corresponding fine-thread Kreg screw for that work.
Yes. The 1-1/2-inch length is the standard size for pocket-hole joinery in 3/4-inch plywood and sheet goods, giving enough thread engagement in the receiving panel without over-penetrating.
This is a coarse-thread screw, which is suited for softwood, plywood, MDF, and particleboard. For hardwood face frames in maple, oak, or cherry, the fine-thread version of this screw is the better fit.
It uses a #2 square drive bit. The square recess is designed to hold the screw on a correctly sized bit for placement in confined assembly positions.
Yes. Coarse thread performs well in particleboard, MDF, and melamine-faced sheet goods, which are common cabinet box materials.
Pocket-hole screws are designed for angled pocket bores. A jig is the most common way to cut that pocket consistently, but it is not strictly required if the pocket is otherwise cut to the correct angle and depth.
When 3/4-inch sheet goods and softwood make up most of what goes through the shop, the Kreg SML-C150 in a 500-piece box keeps the job moving without repeated restocking interruptions.
Sold In: 1 Box