Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg SML-C125 is a #8 x 1-1/4-inch washer-head pocket-hole and face-frame screw with a coarse thread, Type 17 Auger point, and square drive in a zinc finish. It is the standard choice for pocket-hole joinery in softwood and plywood at the 3/4-inch stock thickness that defines most cabinet face-frame work.
At 1-1/4 inches, this screw is matched to the standard pocket-hole jig setting for 3/4-inch material. That length gives the thread enough engagement in the second piece to pull the joint tight while keeping the tip well clear of the opposite face. It is the go-to size for joining rails to stiles, attaching face frames to cabinet boxes, and assembling plywood carcasses where panels run 3/4 inch. Using a screw that is too short leaves the tip shy of full thread engagement; using one that is too long risks breaking through the back face. The 1-1/4-inch length removes that guesswork for the most common face-frame application.
Coarse threads were built for the low-density materials that make up most cabinet carcasses: pine, poplar, plywood, MDF, and similar sheet goods. The wider thread spacing grabs more fiber volume per turn, so pull-out resistance stays strong even in softer stock. The zinc finish is suited to dry, climate-controlled interiors where painted or stained face frames live long-term. This is not the screw for hardwood maple or oak face frames — those applications call for a fine-thread variant — but for softwood and engineered-panel joinery it is exactly what the jig is set up for.
Cabinet shops building face-frame boxes from pine or poplar will find the SML-C125 on the bench at almost every station. It covers rail-to-stile pocket joints, face-frame-to-box attachment, and plywood-to-plywood carcass assembly all at the same jig setting. Furniture builders working in pine, MDF, or birch plywood reach for it when they need a clean, hidden joint that pulls flush without clamps. The 5000-piece count is sized for shops running consistent production volume, where a smaller jar runs out mid-shift and a pail is more than the job needs.
Yes. The 1-1/4-inch length is the Kreg-specified size for pocket-hole joinery in 3/4-inch material. It gives full thread engagement in the second workpiece without the tip breaking through the opposite face.
This screw uses a coarse thread, which is designed for softwood, plywood, and MDF. For hardwood face frames in maple, oak, or cherry, a fine-thread face-frame screw is the better match — the tighter thread pitch reduces splitting and holds better in dense grain.
The washer head provides a flat bearing surface that distributes clamping load across the pocket shoulder. That keeps the joint drawing tight without the head wedging into or splitting the stile — a problem with bugle or countersunk heads in this application.
It takes a #2 square drive bit. Using a correctly sized bit helps the drive engage cleanly in the tight angle of a pocket-hole installation.
No. The zinc finish is rated for dry interior environments. For outdoor or pressure-treated lumber applications, choose a screw with a corrosion-resistant coating rated for exterior exposure.
The Kreg SML-C125 in the 5000-piece box keeps a cabinet shop running through softwood face-frame and carcass work without stopping to reorder — the right length, right thread, and right head for the joint the jig was designed to make.
Sold In: 1 Box