Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #8 x 2-1/2" washer head face frame and pocket-hole screw is sized for joining thicker lumber — 2x material, stacked cabinet components, and structural carcass joints where shorter screws won't reach deep enough to hold. Coarse thread, a Type 17 Auger point, and a zinc finish make this a reliable go-to for softwood and engineered-panel pocket-hole work in production shops and on-site installs.
Most pocket-hole work in 3/4-inch cabinet stock calls for screws in the 1-1/4" to 1-1/2" range. The 2-1/2" length steps in when the joint partner is thicker: face frames built from 2x lumber, back panels glued up from doubled stock, structural cabinet carcasses assembled from 1-1/2" plywood, or angled pocket joints where the screw path has to travel farther to land in solid material. It also covers pocket-hole connections between a face frame and a heavy cabinet box where added thread engagement improves long-term joint stability under drawer and door load cycling. For those applications, undershooting the length means shallow thread bite; this screw provides the reach to do the joint right.
Coarse thread is the right choice for softwood face frames, pine, poplar, plywood, and particleboard — materials where the wider thread pitch bites into the fiber structure and delivers strong pull-out resistance. The washer head distributes clamping load broadly across the pocket shoulder, which matters at 2-1/2" because the longer shank can flex slightly during driving. Keeping the joint tight under those conditions is what the washer head geometry is designed for. The zinc finish is appropriate for dry interior applications: cabinet shops, residential installs, and commercial casework in climate-controlled spaces.
This screw is stocked in 250-piece boxes, a quantity suited to cabinet shops running pocket-hole joinery on face frames, box carcasses, and built-in assemblies. Installers who are joining cabinet runs together on site — driving through a 3/4" face-frame stile into a neighboring box — will find the 2-1/2" length gives them the thread engagement they need in a single pass. The square drive holds the screw on a correctly sized bit, which simplifies placement in overhead installs and tight corner cabinets where a second hand isn't easy to get to the fastener.
This length is designed for thick stock joinery — 2x lumber, doubled cabinet panels, and structural carcass assemblies where standard 1-1/4" or 1-1/2" pocket screws don't provide enough thread engagement in the joint partner.
Yes. Driving through a 3/4" face-frame stile and into the stile of a neighboring cabinet is a common use case for this length. The 2-1/2" reach provides solid thread bite through the combined stock.
This screw carries a coarse thread, which is the correct choice for softwoods, plywood, and pine. For hardwood face frames in maple, oak, or cherry, a fine-thread face-frame screw is the better fit — coarse thread in dense hardwood can split the stile.
The Type 17 Auger point has an extended flute that clears wood chips out of the hole as the screw advances. In thick stock, where the screw travels a longer path, that chip clearing reduces the torque buildup that can strip the drive or cause the screw to stall before seating.
The screw is a standard #8 coarse-thread pocket-hole screw with a washer head. Whether it works with a given jig depends on the jig's pocket geometry and the recommended screw spec for that jig and stock thickness — check the jig manufacturer's screw selection guide for the thickness you're joining.
When the job calls for pocket-hole joinery in thick lumber or stacked cabinet panels, the 2-1/2" length delivers the thread engagement that shorter screws can't, keeping structural joints tight through years of load and use.
Sold In: 1 Box