Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #8 x 1-1/4" Face Frame and Pocket-Hole Screw is sized for standard 3/4-inch softwood and sheet-goods joinery, including face frame assembly, cabinet box construction, and general pocket-hole work where a coarse thread is appropriate for the material.
In pocket-hole joinery, screw length is matched to the thickness of the material being joined. At 1-1/4 inches, this screw is calibrated for 3/4-inch stock — the thickness used in most cabinet face frames, plywood boxes, and furniture carcasses. Driving it through the angled pocket bore into 3/4-inch stock gives the thread full engagement without breaking through the far face. For shops running cabinet boxes, assembling face frames, or building furniture in softwood or sheet goods, this is the go-to length in the Kreg coarse-thread line.
The washer head is wider and flatter than a countersunk profile, so it bears against the pocket wall and pulls the joint closed rather than wedging through it. That matters in softwood and engineered panels, where a countersunk head can split thin stock or pull through under clamping load. The coarse thread is matched to low-density materials: pine, poplar, plywood, particleboard, MDF, and melamine all hold coarse threads better than fine. The Type 17 auger point adds a flute near the tip that clears wood fibers as the screw enters, reducing the torque needed to seat the screw fully and helping the head land flush without tearing the pocket.
Cabinet shops running softwood or plywood face frames will use this length the most — it is the default size for 3/4-inch stile-to-rail and frame-to-box joints. Furniture builders working in pine or poplar reach for it the same way. It also covers plywood and melamine cabinet box assembly, shop jig construction, and any pocket-hole application in softwood where the pieces being joined are 3/4 inch thick. Hardwood face frames in maple, oak, or cherry call for a fine-thread screw instead; the coarse thread on this one is right for softer species and engineered panels. Each box holds 250 screws.
Coarse threads grip softwood and sheet goods — pine, poplar, plywood, MDF, melamine — better than fine threads do in those materials. Fine threads are the right choice for dense hardwoods like maple or oak, where coarse threads can strip under torque. This screw's coarse thread is built for the softer species and engineered panels most commonly used in cabinet face frames.
For 3/4-inch stock, Kreg jig settings are typically set to the 3/4-inch mark, which positions the pocket at the right depth and angle for a 1-1/4-inch screw. Check the jig's setup guide for the exact collar depth and drill guide setting, since they vary by jig model.
Yes. Driving a 1-1/4-inch pocket-hole screw through the face frame into the front edge of a 3/4-inch plywood cabinet side is a common attachment method. The washer head pulls the frame tight against the box face without cracking the frame stock.
The square recess is designed to hold the screw on a correctly sized bit for one-handed placement — useful when driving into a pocket at an angle with limited working room. That retention works best with a properly fitting #2 square bit; a worn or off-spec bit may not hold as securely.
The zinc finish on this screw is rated for dry indoor use. For outdoor or high-humidity applications, look for a screw with a coating rated for exterior or treated-lumber exposure.
At 1-1/4 inches with a coarse thread, washer head, Type 17 auger point, and square drive, this Kreg screw covers the most common pocket-hole joint in cabinet and furniture work — 3/4-inch softwood and sheet goods — with the geometry each of those elements is designed to handle.
Sold In: 1 Box