Nickel Angled Hinge for Full Overlay Doors on 30-Degree Cabinets

This Blum CLIP top III angled hinge hangs full overlay doors on cabinets built to a 30-degree outward angle, with INSERTA tool-free mounting and a self-close spring, on both face-frame and frameless boxes.

Key Features

• 30-degree positive cabinet angle geometry fits doors on outward-angled bay and diagonal cabinet faces.
• Full overlay arm covers nearly the entire cabinet side, leaving a narrow reveal.
• Self-close spring pulls the door shut over the last few degrees of travel.
• INSERTA tool-free plate mounting presses the base plate into pre-drilled 5mm system holes without screws.
• 110-degree opening delivers standard everyday access on the angled face.
• Three-way adjustment dials height, side, and depth after the door is hung.

Built for Angled Cabinets, Not Standard Boxes

When a run of cabinetry turns a corner or steps outward at a 30-degree angle, a standard hinge cannot bridge the geometry. This Blum CLIP top III hinge is engineered specifically for that outward +30-degree cabinet face. The 35mm cup bores into the back of the door as usual, but the arm geometry angles the door to sit correctly over the angled cabinet side at a full overlay. It works on both frameless cabinets and face-frame construction, so the same hinge suits production shops running either type. A matching Blum base plate mounts to the cabinet and the arm clips on without tools. The plate is sold separately and must be a Blum plate sized to your cabinet and overlay.

Steel Construction, Nickel Finish, Reliable Spring

The hinge body is plated steel in a nickel finish, a neutral tone that recedes into the cabinet interior. The self-close spring pulls the door shut once it reaches the last few degrees of travel. This is a spring-pull close, not a soft-close damper: the door closes firmly on its own, without cushioning. For angled cabinets that see daily traffic, the three-way adjustment lets an installer bring every door to an even reveal after the run is set, and re-square a door that shifts as the cabinet settles over time.

Where This Hinge Belongs

Specify this hinge for angled specialty cabinets: diagonal corner units, bay-front kitchen designs, or any casework where the cabinet face turns outward at 30 degrees. It suits cabinet shops building custom angled runs, designers specifying diagonal corner storage, and contractors installing prefabricated angled units. INSERTA plate mounting requires pre-drilled 5mm system holes in the cabinet side. If the cabinet does not have system holes, use the screw-on plate version instead. For doors thicker than 22mm, a thick-door hinge is the correct choice. And if a damped, quiet close matters more than a spring pull on this application, the BLUMOTION soft-close version of this angle hinge is the one to order.

Common Questions

The Right Geometry for Doors That Follow the Angle

When the cabinet face turns, the hinge has to turn with it. This Blum CLIP top III angled hinge in nickel keeps full overlay doors square and self-closing on outward 30-degree cabinets, with tool-free INSERTA mounting that keeps the install moving.