Nickel Angled Hinge for Full Overlay Doors on 30-Degree Cabinet Faces

This Blum CLIP top III concealed hinge is built for full overlay doors on cabinets set at a 30-degree outward angle, the geometry used in bay-style and diagonal corner cabinet runs. It works on both frameless and face-frame cabinets and uses INSERTA tool-free plate mounting for a clean, fast install.

Key Features

• 30-degree positive cabinet angle is engineered for outward-facing bay and diagonal cabinet configurations, not a standard 90-degree box.
• 95-degree opening angle gives the correct swing geometry for a door on an angled face without binding against the adjacent cabinet.
• Full overlay arm covers nearly the entire cabinet side, leaving a narrow reveal between doors.
• Self-close spring pulls the door shut over the last few degrees of travel.
• INSERTA tool-free mounting presses the base plate into pre-drilled 5mm system holes so no plate screws are needed.
• Three-way cam adjustment moves the door in height, side, and depth after hanging to dial in an even reveal.

The Right Hinge for an Angled Cabinet Run

Bay and diagonal cabinet layouts place the door face at an angle rather than flush with a straight run, and a standard 90-degree hinge cannot bridge that geometry correctly. This hinge is built for the positive 30-degree cabinet angle, where the cabinet face turns outward, so the arm and cup geometry hold the door in the right plane as it opens and closes. The 35mm cup bores into the back of the door, and the arm connects to a Blum base plate mounted to the cabinet, sold separately. The 95-degree opening is the designed swing for this angle: it gives full access to the door interior while keeping the door clear of adjacent panels.

Steel Build in a Nickel Finish

The hinge body is plated steel in a nickel finish, consistent with the finish language across Blum's CLIP top III range. The nickel tone coordinates with brushed metal hardware on cabinet interiors and is a practical choice for runs where some hardware remains visible after the door swings open. Three-way adjustment built into the arm lets installers correct height, side, and depth position at the cabinet after hanging, so the reveal stays even across a multi-door angled run without disassembly.

For Bay Layouts on Frameless and Face-Frame Boxes

Cabinet shops and contractors specifying a bay or diagonal corner section will find this hinge covers both frameless and face-frame construction, so the same part works across a mixed project. INSERTA plate mounting requires pre-drilled 5mm system holes in the cabinet side; if those holes are not present, use the screw-on plate version instead. For doors outside the standard 16 to 22mm thickness range, confirm fit before ordering. This is a self-close hinge: the spring pulls the door shut, but it does not cushion the close. If a damped, quiet close is a project requirement, the BLUMOTION soft-close version in this angle series is the alternative to specify.

Common Questions

Angled Doors That Close Cleanly and Sit Square

Specify this hinge when a bay or diagonal layout calls for full overlay doors that close on their own, mount fast with INSERTA, and hold their adjustment in a nickel finish across the full run.