Nickel Angled Hinge for Half Overlay Doors on 20-Degree Cabinets

This Blum CLIP top angled concealed hinge is built for half overlay doors on cabinets set at a 20-degree outward angle, working on both face-frame and frameless construction with toolless INSERTA plate mounting and a self-close spring.

Key Features

• 20-degree outward cabinet angle fits bay-style and angled cabinet configurations where the face is not square to the wall.
• Half overlay arm geometry positions the door over the cabinet side, suited for two doors sharing a center partition or a partial-overlay layout.
• 95-degree opening provides the correct swing for the geometry of this angled application.
• Self-close spring pulls the door shut automatically over the last few degrees of travel.
• INSERTA toolless mounting presses the base plate into pre-drilled 5mm system holes without screws.
• Three-way adjustment dials height, side, and depth after the door is hung.

The Right Hinge for an Angled Cabinet Opening

On a bay cabinet or a run with a 20-degree outward angle, a standard straight-bore hinge cannot close the door cleanly. This hinge is engineered to that specific cabinet geometry, so the door travels the correct arc and rests flat against the face when closed. The 35mm cup bores into the back of the door in the standard way, but the arm is angled to match the cabinet face, not a 90-degree box. Pair it with the matching Blum base plate, ordered separately, which mounts to the cabinet side or frame stile. The hinge arm then clips to that plate without tools.

The 95-degree opening is the designed swing for this geometry. On an angled cabinet, that angle delivers full practical access without the door swinging into an adjacent surface or the neighboring cabinet. It is the correct spec for this application, not a constraint.

Steel Build in a Nickel Finish

The hinge body is plated steel finished in nickel, a neutral tone that sits quietly inside the cabinet and coordinates with most drawer slides and other hardware in the same run. Nickel is a durable, low-maintenance finish for an interior application that sees daily use. Three-way adjustment keeps doors aligned over time: a turn of the cam screws corrects height, side, or depth as the cabinet settles, without removing the door.

Where This Hinge Belongs

Specify this hinge when the design includes a bay or angled cabinet section with a 20-degree outward face and doors set to a half overlay. It works on face-frame stiles and frameless panel edges, so it covers both traditional and European-style cabinet boxes in the same run. INSERTA mounting assumes the cabinet has pre-drilled 5mm system holes. If the box was built without them, the screw-on plate version of this hinge is the correct substitute. Cabinet shops running angled specialty pieces and contractors finishing out a kitchen with a bay section will both find this hinge fits the install without modification.

Common Questions

Angled Cabinet Work Finished Right

When the cabinet face breaks away from square, this hinge keeps the door fitting and closing correctly, with toolless mounting and the adjustability to dial it in on site.