Würth #7 x 1-1/4" Modified Pan Head Face Frame and Pocket-Hole Screw Square Drive - Type 17 Auger Point Hi-Lo Lubricated, 3670000195961 7500 - 7500/Box

Square Drive Face Frame and Pocket-Hole Screw Sized for 3/4-Inch Stock

This Würth #7 x 1-1/4" face frame and pocket-hole screw is built for joining 3/4-inch cabinet stock, where the length, thread, and head geometry work together to pull joints tight without splitting the material. Part of the Würth Pocket Master series, it combines a Hi-Lo thread, modified pan head, Type 17 Auger point, square drive, and a lubricated finish into a production-ready fastener for cabinet shops and finish carpenters.

Key Features

• Hi-Lo thread alternates high and low thread profiles to reduce driving torque and deliver strong pull-out resistance in both hardwood and softwood face-frame stock.
• Modified pan head provides a broad, flat bearing surface that pulls the joint tight without wedging or splitting the stile.
• Type 17 Auger point features an extended flute that clears wood fibers ahead of the threads, reducing splitting in dense hardwoods like maple, oak, and cherry.
• #2 square drive is designed to hold the screw on a correctly sized bit for controlled, cam-out-resistant placement in tight cabinet interiors.
• Lubricated finish lowers installation torque for faster driving across high-volume assembly runs.
• Packed 7,500 per box to keep production shops stocked through long runs without constant reordering.

The Right Length for 3/4-Inch Face-Frame Joinery

At 1-1/4 inches, this screw is the standard specification for pocket-hole joints in 3/4-inch stock. That length provides thread engagement deep enough for a secure joint without over-penetrating the mating piece. It suits the most common face-frame scenario in cabinet production: joining rails to stiles in 3/4-inch hardwood or softwood, and attaching the completed face frame to the cabinet box. The Hi-Lo thread handles both hardwood species like maple and oak and softwood or sheet-good frames without switching screws between jobs.

Thread and Head Design That Protects the Joint

The Hi-Lo thread alternates between a sharp, deep 30-degree high thread and a shorter 60-degree low thread. The high thread cuts for pull-out resistance; the low thread stabilizes the shank between passes. Together they reduce the radial pressure that splits narrow stile stock under a coarse single-thread design. The modified pan head complements this: its flat underside bears evenly across the pocket wall and draws the joint closed without the wedging action of a bugle or countersunk head. For cabinet shops running maple, cherry, walnut, or mixed-species frames, this combination means fewer splits and cleaner joints at the point of assembly.

Built for Cabinet Shops Running High Volume

The lubricated finish and Type 17 Auger point are what make this screw practical at production pace. The auger flute clears chips ahead of thread engagement, which matters most in dense hardwood where a standard sharp point would require more torque and risk blowout near the edge. The lubricated coating keeps driving resistance low across a full shift, reducing fatigue and bit wear when the same motion repeats several hundred times a day. A box of 7,500 screws means fewer restocking interruptions, making it a practical choice for cabinet shops, millwork operations, and production carpentry teams who run face frames daily.

Frequently Asked Questions

A Production-Ready Screw for Every Face Frame on the Schedule

When the job is 3/4-inch face frames in hardwood or softwood, this Würth Pocket Master screw puts the right length, thread, head, point, and drive in one fastener so the joint closes clean and the line keeps moving.