Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg SML-C150-1200 is a #8 x 1-1/2-inch face frame and pocket-hole screw designed specifically for joining 3/4-inch softwood, plywood, MDF, and pine. The washer head, coarse thread, and Type 17 Auger point work together to pull pocket-hole joints tight and seat cleanly without splitting the workpiece.
At 1-1/2 inches, this screw is calibrated for the most common pocket-hole joint in cabinetry: two pieces of 3/4-inch stock drawn together at the face or edge. That length puts enough thread into the receiving piece for solid pull strength without over-penetrating thin panels. It is the go-to size for building face frames, assembling cabinet boxes from plywood or MDF, and joining softwood furniture components where a pocket jig is part of the workflow. For hardwood face frames, a fine-thread screw is the better match. This coarse-thread version is built for softer materials where the wider thread pitch locks in and holds.
The washer head sits flat against the angled pocket wall and spreads the clamping load across a wider bearing surface than a standard pan head. That broad contact is what pulls the joint tight and keeps it from loosening under the stresses of cabinet assembly. The Type 17 Auger point starts the screw quickly in softwood without requiring a pilot hole, and the fluted tip clears chips as the screw drives, which reduces the torque needed to seat the head flush. The #2 square drive recess is designed to hold the screw on a correctly sized bit, making one-handed placement practical at the pocket opening.
This screw is a natural fit for cabinet shops and finish carpenters who work primarily with softwood, plywood, or sheet goods and run pocket-hole jigs as a standard part of assembly. A 1200-count box supports production-volume work without constant restocking. Renovation contractors building or installing face-frame cabinets in paint-grade poplar or pine will find the coarse thread and 1-1/2-inch length handle the full range of those joints cleanly. It is an indoor screw for dry environments. If the project involves pressure-treated lumber or exterior exposure, a screw with a heavier corrosion-resistant coating is the appropriate choice.
Pocket-hole joinery drives the screw at an angle through the pocket and into the mating piece. At 1-1/2 inches, enough thread reaches into the second workpiece to create solid pull strength without the tip breaking through the far face of a standard 3/4-inch panel.
The coarse thread on this screw is optimized for softwood, plywood, MDF, and pine. Hardwood face frames in maple, oak, or cherry call for a fine-thread pocket-hole screw, which provides better thread engagement and reduces the risk of splitting tight-grained stock.
No. The washer head is designed to bear flat against the angled face of the pocket hole. A standard pocket-hole jig produces the correct pocket geometry for this head style without any additional countersinking step.
Yes. The 1-1/2-inch length and coarse thread are well suited for pocket-hole joints in 3/4-inch plywood cabinet boxes. The washer head and Type 17 Auger point handle plywood reliably without splitting the veneer at the joint.
No. The zinc finish on this screw is suited to dry indoor environments. Outdoor work or pressure-treated lumber requires a screw with a heavier corrosion-resistant coating rated for exterior or ACQ-treated wood exposure.
When 3/4-inch softwood, plywood, or sheet goods are the material on the bench, this Kreg screw is sized and threaded to handle those joints from the first pocket to the last panel.
Sold In: 1 Box