Nickel Half Overlay Concealed Hinge for Face-Frame and Frameless Cabinets

This Salice Series 100 hinge hangs half overlay doors on both face-frame and frameless cabinets, with a self-close spring and a nickel finish, using a screw-on mount.

Key Features

• Self-close spring pulls the door shut over the last few degrees of travel automatically.
• Half overlay, half crank arm positions the door at a partial overlap, suited to shared-partition door pairs.
• 105 degree opening delivers practical everyday access on partial-overlay doors.
• Screw-on mount fastens directly to the cabinet with no tool-free system holes required.
• Nickel finish on steel gives the hinge a clean, understated look where hardware is visible during install or service.
• Height and side adjustment lets you dial in an even reveal after installation.

Where Half Overlay Geometry Does the Work

Half overlay is the geometry for doors that cover only part of the cabinet side, most often where two doors share a single center partition and each one overlaps about half of it. A full-overlay hinge in that situation puts the arms in conflict; this half crank arm steps back exactly the right amount so both doors hang without interference. The 35mm cup bores into the back of the door face, and the hinge arm connects to a base plate fastened to the cabinet side, ordered separately. Salice plates are brand-specific, so pair this hinge with the matching Salice plate for your cabinet construction.

Steel Build in a Nickel Finish

The hinge is stamped steel with a nickel plating. Nickel reads as a quiet, neutral tone that sits comfortably alongside stainless pulls, brushed hardware, or chrome fixtures without competing for attention. The screw-on mount is the straightforward connection here: wood screws into the cabinet, no pre-drilled 5mm system holes needed, which makes it a practical fit on site-built and custom cabinets where the 32mm system grid was not part of the original plan. Height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm and minus 1.5mm give enough range to square up a row of doors after the boxes are set.

Who Reaches for This Hinge

This is a working hinge for builders, remodelers, and cabinet shops running partial-overlay door layouts on either frameless boxes or face-frame cabinets. The screw-on mount makes it accessible on any project regardless of boring setup, and the Salice Series 100 delivers dependable self-close performance without the cost premium of the soft-close Silentia line. For projects where cushioned, damped closing is a spec requirement, the Silentia+ soft-close version of this series is the right step up. For standard partial-overlay work where the door just needs to close on its own and stay there, this hinge does the job cleanly.

Common Questions

Reliable Self-Close on Every Partial-Overlay Door

Specify this hinge when the job calls for half overlay doors that close on their own, mount without system holes, and carry a finish that blends with the rest of the hardware.