Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rev-A-Shelf 6541 Series sink tip-out tray converts the unused space behind a sink's false drawer front into a shallow storage compartment for sponges, scrubbers, soap pads, and small cleaning tools. It is made from stainless steel and opens and closes on self-close hinges.
The strip of cabinet space directly behind a sink's false drawer front is almost always wasted. There is no drawer there, only a narrow void that collects drips and nothing else. A tip-out tray installs behind that front so it tilts outward when you press or pull the face, revealing a shallow trough that holds the items that typically sit on the counter or the sink ledge. Sponges, scrubbers, dish soap packets, and soap-dispensing brushes all fit without cluttering the counter, and they are a few inches away whenever you need them.
The tray is stainless steel, which is a practical choice for this specific location. A sink tip-out tray lives in a wet zone: the items it holds are damp, and water from the basin occasionally splashes back. Stainless steel does not absorb moisture or corrode the way raw steel would, and its surface is easy to wipe down. The finish also coordinates naturally with stainless steel sinks, faucets, and appliances without requiring a finish match to cabinetry hardware. The self-close hinges are included with the tray and handle the opening and closing motion, so the tray comes back in reliably without being pushed fully shut by hand.
This tray is sized for a 13-inch false drawer front, the common width in a single-sink base cabinet. Kitchen renovations and new cabinet installs where the sink run has not yet been assigned a tip-out tray are the primary use case, and so is replacing an existing tray that has worn out or does not match new hardware. The stainless finish makes it a natural fit when the rest of the sink area is already stainless, such as in a modern kitchen with a stainless undermount sink or a professional-style range setup. Designers specifying a cohesive hardware story across a kitchen can use this tray to carry the stainless material through to the sink cabinet detail without introducing a contrasting finish.
The set includes one stainless steel tray and two self-close hinges.
A tab stop is a built-in limiter that restricts how far the tray can tilt open. This tray does not have one, so it opens to a wider angle, which makes it easier to load and unload items.
Stainless steel is the right material for this location. It resists moisture and is easy to wipe down, so damp items sitting in the tray will not cause the surface to stain or corrode.
At 13 inches long, it fits most single-sink base cabinet false fronts. Measure the usable interior width of your false-front opening before ordering to confirm the fit.
Specify this stainless steel tip-out tray to move everyday sink tools off the counter and into the unused space behind the false drawer front, with self-close hinges and a finish that belongs in a wet zone.
Sold In: 1 Each
