Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a metal narrow rear mounting bracket for Salice Futura undermount drawer slides, designed to support the back end of the slide in face-frame cabinet installations where cabinet depth or frame geometry requires a narrow-profile socket.
Futura undermount slides need a solid mounting point at the cabinet rear whenever the slide is installed in a face-frame cabinet. Without rear support, the back of the slide is unsupported, which lets the drawer rack and throws the front adjustment off. This narrow rear bracket fills that role in cabinets where the standard-width socket does not fit — shallow rear rails, narrow stiles, or tight interior clearances that make the wider bracket impractical. If your Futura slide installation called for a rear socket and the standard bracket was too wide, this is the replacement to reach for.
The bracket is metal throughout, which keeps it rigid under load and resistant to the flex that can cause a mounted drawer to shift out of adjustment over time. The narrow form is a deliberate dimensional choice for the applications above, not a lighter-duty version of the standard socket — the 75 lb rating applies to the complete Futura system as installed.
This bracket suits cabinet shops and installers working with Salice Futura undermount slides in face-frame casework where rear support is needed and interior clearance is limited. Order one bracket per slide; a standard Futura drawer uses two slides, so most installations require two brackets. Futura rear brackets are series-specific — do not substitute brackets from other Salice lines or other undermount programs, as the mounting geometry will not match.
In frameless cabinets the slide screws directly to the cabinet side and rear support is built into that mount. In face-frame cabinets the cabinet side is set back from the face frame, so the rear of the slide is unsupported without a bracket. If your Futura installation is in face-frame construction, a rear bracket at the back of each slide is required.
The narrow bracket has a reduced width that fits rear-mounting locations where the standard Futura socket will not clear — typically tighter rear rails or interior conditions with limited side-to-side room. If the standard bracket fits your cabinet, use it; if the standard bracket is blocked by the cabinet geometry, the narrow version is the solution.
No. Futura rear brackets are built to the Futura mounting geometry and are not compatible with other Salice series or slides from other manufacturers. Always match the bracket to the exact slide series in the installation.
One bracket supports one slide. A standard drawer runs on two slides, so plan on two brackets per drawer opening in a face-frame cabinet.
The right rear bracket keeps a Futura undermount drawer tracking true from day one — and saves the adjustment time that follows when the back end of the slide is left without proper support.
Sold In: 1 Each
