Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the LEGRABOX M-height drawer profile in Stainless Steel — a 20 inch (500mm) steel side profile that forms the structural wall of a Blum LEGRABOX drawer system. Sold as a matched left-hand and right-hand pair, these profiles replace wood drawer sides entirely and integrate the runner into the wall of the box.
The M-height profile occupies the practical middle of the LEGRABOX height range — tall enough to contain a well-stocked cutlery or utensil drawer, compact enough for stacked kitchen or bath configurations where a taller side would crowd the cabinet above. A 20 inch nominal length suits standard base cabinet depths across kitchen, bath, and office casework. Shops running LEGRABOX throughout a project use the 500mm profile as their everyday workhorse length, pairing it with the corresponding runners, front fixings, and steel back panels in the same nominal length.
Stainless Steel is the finish to choose when the drawer interior will be visible — open-face kitchen drawers, showroom displays, or any installation where the inside of the box reads as a design surface rather than a utilitarian liner. The finish coordinates with AMBIA-LINE organization inserts offered in stainless, so a cutlery tray or utensil insert can match the side profile rather than contrast with it. The double-walled steel construction means there are no visible fasteners on the interior face: what the homeowner or end client sees is a continuous, smooth steel wall on each side of the drawer.
Cabinet shops running Blum LEGRABOX as their primary drawer system will recognize this as a standard component reorder — the profile to reach for when a project calls for 500mm boxes at M height and the finish spec is Stainless Steel. Designers specifying handle-less or minimalist kitchens often call out stainless interiors precisely because the polished surface reads well with both warm wood fronts and lacquered or glass drawer faces. Contractors installing pre-specified LEGRABOX cabinetry should confirm that the runners, front fixings, and steel backs on the job match this 500mm nominal length before ordering.
Yes. The profiles ship as a matched left-and-right pair — one order equips both sides of a single drawer.
You will need the matching 500mm LEGRABOX runner, front fixing brackets sized to the M-height profile, a steel back panel at the correct width, and a drawer bottom cut to the system's published formula. All components must be 500mm nominal length from the LEGRABOX platform — parts from other Blum systems or other nominal lengths do not interchange.
No. ORGA-LINE is the organization line for TANDEMBOX drawers. LEGRABOX drawers use AMBIA-LINE inserts, available in stainless steel to match this profile's finish.
LEGRABOX profiles mount directly in frameless (32mm grid) cabinets. Face-frame installations require the appropriate rear mounting brackets — confirm the bracket requirements for your specific cabinet construction before ordering.
M height is 90.5mm (3-9/16 inches) — the mid-range option. Lower heights suit shallow cutlery drawers; taller heights suit pot drawers and pantry pull-outs. Choose the height based on the contents the drawer will carry and the clear interior dimension available in the cabinet.
The LEGRABOX M-height profile in Stainless Steel delivers the structural performance of a double-walled steel drawer side with a finish that stays visible and presentable over the life of the installation — a practical choice for kitchen and bath projects where the drawer interior is part of the design.
Sold In: 1 Set
