Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Knape & Vogt 8810 series is a 16 inch full-extension side-mount ball bearing drawer slide rated 200 lb per pair, finished in zinc, and sold in bulk. It fills the gap between the standard 100 lb cabinet class and specialty heavy-duty work, making it a direct choice for shop drawers, tool storage, and any application where the load routinely pushes past what a kitchen-class slide can handle.
A 200 lb per pair rating puts the 8810 series well above the kitchen and office drawer class. Tool drawers stocked with sockets and wrenches, hardware bins carrying box counts of fasteners, and utility pulls loaded with shop supplies all land comfortably within this slide's range. Full extension means nothing gets buried at the back — the drawer box comes all the way out to the cabinet face, so the last item in the drawer is as reachable as the first.
Steel slide members carry a zinc finish that resists the everyday moisture and grime of a shop or garage setting. Zinc is a functional indoor finish — it does the protective job without adding visual weight or cost. It is not a decorative or stainless finish, and it is not rated for wet or corrosive environments. For indoor shop, utility, and commercial cabinetry, it is the right call.
The 8810 series makes the most sense when the drawer load is the primary selection driver. Cabinet shops building tool storage, contractors outfitting a job-site cabinet, and homeowners fitting out a serious garage workbench all benefit from the 200 lb rating at a 16 inch slide length. The non-handed format means a single bulk order covers an entire run of drawers without sorting or swapping parts. Because the motion is standard, there is no closing mechanism to interfere with a push-to-open retrofit if that comes later. Note that the 3/4 inch side clearance per side is wider than the 1/2 inch used on standard cabinet slides — the drawer box width must reflect this before cutting.
The 200 lb capacity is rated per pair of slides — both slides working together as installed on one drawer.
No. The 16 inch measurement is the closed slide length. Because the extension is full, the drawer travels approximately the full slide length and clears the cabinet face entirely — but slide length and drawer travel are two separate specifications.
Yes. The 8810 series calls for 3/4 inch of side clearance per side, so the drawer box should be built 1-1/2 inches narrower than the cabinet opening total. This is wider than the 1/2 inch clearance used on the standard KV 8400 class slides.
Standard motion means no soft-close damper, no self-close spring, and no hold-in detent. The drawer rolls freely and stops wherever it is left. If a closing feature matters, look at the soft-close or hold-in variants in the 8810 lineup.
Side-mount slides in a face-frame cabinet need rear support at the back end of the slide. Add the appropriate series-matched rear mounting brackets, sold separately, to complete the installation.
When the drawer load moves past what the kitchen class is built for, the 8810 series zinc slide steps in with a 200 lb per pair rating, full extension, and a non-handed format that makes ordering a bulk run straightforward.
Sold In: 4 Set
