Hettich Quadro V6 Undermount Drawer Slide for Compact Frameless Drawers

The Hettich Quadro V6 250mm undermount drawer slide is a right-hand, full-extension, soft-close runner built for frameless cabinet installations with shallow drawer depths. At a 10 inch nominal length with an 11 inch minimum installation depth, it suits spice drawers, narrow rollouts, and any compact frameless drawer that demands concealed, damped operation in a tight footprint.

Key Features

• Full extension brings the entire drawer out to the cabinet face, putting every inch of a short drawer within reach.
• Integrated soft-close catches the drawer near the end of travel and settles it shut silently, with no slamming.
• Right-hand cabinet member — pair with a matching left-hand unit to complete one drawer installation.
• Ball bearing construction on a steel body delivers smooth, consistent travel under load.
• 90 lb weight capacity per pair handles a fully loaded compact drawer with headroom to spare.
• Zinc finish blends with the cabinet interior and provides durable indoor corrosion resistance.

Where This Slide Fits the Job

A 10 inch nominal slide addresses the short end of the frameless drawer spectrum — the spice pullout beside the range, the narrow tray under a peninsula, the small utility drawer in a bath vanity. Full extension matters especially in short drawers: when the box is only 10 inches deep to begin with, 3/4 extension leaves the back unreachable. This slide brings the whole drawer out so nothing is buried. The integrated soft-close keeps that small-but-busy drawer quiet through daily use, and the 90 lb per-pair capacity handles contents far heavier than the box size might suggest.

Construction and Finish

The Quadro V6 runner is built from steel with a zinc finish, which protects the slide through years of indoor use. Ball bearing travel is the standard for undermount slides in this class — precise, consistent, and smooth even under load. The integrated soft-close damper is part of the slide mechanism itself, not an add-on, so no additional adapter or accessory is needed to get damped closing on this unit. The slide accommodates drawer sides from 1/2 inch to 5/8 inch thick, which covers the most common drawer box thicknesses in frameless production cabinetry.

Who Reaches for This Slide

Cabinet shops running short frameless drawer banks — kitchen spice towers, bath storage columns, built-in desk pedestals — will find the 250mm length fills a gap that standard 12 inch or longer slides cannot. A frameless-only slide installs directly to the panel side on the 32mm system grid, so no rear brackets or special adapters are required for the cabinet build. Designers specifying handle-less or minimalist interiors get concealed, soft-close operation without visible hardware when the drawer is open. Contractors sourcing for a tight millwork installation can confirm fit with the 11 inch minimum installation depth before ordering.

The Right Slide for a Small, Hard-Working Drawer

When the drawer is compact and the install is frameless, the Quadro V6 250mm right-hand runner delivers full extension, integrated soft-close, and 90 lb capacity in a 10 inch slide — exactly what a short drawer demands from a concealed undermount.