Hettich Quadro V6 Undermount Drawer Slide for Frameless Cabinets, Right Hand

This right-hand Quadro V6 undermount drawer slide brings full-extension travel and integrated soft-close to frameless cabinet builds on a compact 320mm (12-9/16 inch) nominal length. Sold as a single right-hand cabinet member, it pairs with the matching left-hand member to complete one drawer installation.

Key Features

• Full extension pulls the entire drawer out to the cabinet face, putting the back of the box fully within reach.
• Integrated soft-close catches the drawer near the end of travel and settles it shut silently without a separate add-on damper.
• 90 lb weight capacity handles a fully loaded kitchen or bath drawer with capacity to spare.
• Ball bearing construction rolls smoothly under load and holds up through repeated daily cycling.
• Right-hand orientation mounts to the right side of the cabinet interior; pair with the left-hand version for a complete set.
• Zinc finish protects the steel members through years of indoor service.

Built for Compact Frameless Drawer Runs

At 320mm nominal length, this slide suits shorter drawers in frameless kitchen base cabinets, bath vanities, and furniture pieces where a longer slide would not fit the interior depth. The 13-9/16 inch minimum installation depth means the cabinet only needs to be fractionally deeper than the slide itself, which keeps the option open in tighter builds. Full extension is the right call for drawers where the contents need to be reachable all the way to the back — spice drawers, utensil drawers, and bathroom storage where the full box depth is used regularly. Because this is a right-hand cabinet member, the slide mounts on the right interior wall of the frameless cabinet and attaches to the right side of the drawer box via the locking device at the front.

Construction and Finish

The Quadro V6 is a steel ball-bearing slide with a zinc finish — a practical, durable combination for indoor cabinet work. The zinc plating protects the steel through daily use without adding visual weight or bulk inside the cabinet. Soft-close is built into the slide rather than retrofitted, so the damping behavior is consistent from the first cycle. The slide accepts drawer sides from 1/2 inch to 5/8 inch thick, which covers most plywood and solid-wood box construction in this size range. Frameless installation is direct: the cabinet member screws to the flat interior panel, no rear bracket required.

Who Reaches for This Slide

Cabinet shops running frameless box lines with shorter drawer depths reach for this slide when the drawer spec calls for full extension and soft-close but the cabinet interior is too shallow for a longer member. It also suits kitchen and bath installers replacing or specifying slides in existing frameless cabinetry where the 320mm length is the right match. Designers specifying for residential kitchens, bath vanities, or bedroom furniture can rely on the 90 lb rating and full-extension travel to meet the functional expectations of the finished piece. Because it is a single handed member, it is straightforward to order the correct quantity: one right-hand and one left-hand member per drawer.

The Right Member for the Right Drawer

When the frameless cabinet is shallow, the drawer depth is 320mm, and the spec calls for full extension with soft-close, this right-hand Quadro V6 member is the piece that goes on the right wall — pair it with its left-hand counterpart and the correct locking devices, and the drawer is ready to run.