Hettich Quadro V6 Undermount Slide For Right-Hand Frameless Cabinet Installations

This Hettich Quadro V6 right-hand undermount drawer slide pairs ball-bearing precision with integrated soft-close in a 350mm (13-3/4 inch nominal) format sized for 14-inch drawer boxes. It mounts beneath the drawer box, stays hidden when the drawer is open, and delivers full extension so the entire drawer clears the cabinet face.

Key Features

• Full extension brings the entire drawer out to the cabinet face, putting every inch of the interior within reach.
• Integrated soft-close catches the drawer near the end of travel and settles it shut silently without a separate damper add-on.
• 90 lb weight capacity per pair handles a fully loaded kitchen or bath drawer with room to spare.
• Ball-bearing construction rolls smoothly under load and holds its action through years of daily use.
• Right-hand orientation — this is a single cabinet member; pair with the matching left-hand member to complete one drawer installation.
• Zinc finish steel provides corrosion resistance suited to indoor cabinet environments.

Where This Slide Fits the Work

At 350mm nominal length, this slide suits drawer boxes built to the 350mm depth specification — the right size class for a standard 14-inch kitchen or bath drawer. Full extension means a pull-out spice drawer, a pot-and-pan base, or a vanity accessory drawer opens completely clear of the cabinet, not partway. The concealed undermount position keeps hardware out of sight so the interior of the drawer is the only thing visible when the box is open, a priority in finished residential and light commercial cabinetry where the inside of a drawer matters as much as the front.

The 14-3/4 inch minimum installation depth means the cabinet interior needs to be at least that deep from face to back panel; measure before ordering to confirm clearance. This version is engineered for frameless (European-style) cabinet construction, where the slide mounts directly to the flat interior side panel.

Build and Finish

Steel construction with a zinc finish gives the slide durability in the dry, indoor environments where frameless residential cabinetry lives. Ball bearings run in formed steel raceways, delivering consistent, low-effort travel across the full extension range. The soft-close mechanism is built into the slide itself, so there is no separate damper device to purchase, mount, or adjust after installation.

This slide accommodates drawer sides between 1/2 inch and 5/8 inch thick. Build the drawer box to Hettich's published Quadro V6 specification, including the correct box width formula, rear notch, and any required locking-device drilling. A box built outside that spec will not seat and lock correctly on the slide.

Who Orders This Slide

Cabinet shops producing frameless kitchens and baths reach for the Quadro V6 when soft-close, full extension, and a concealed profile are all on the specification. The 90 lb pair rating covers the load range a residential drawer faces without stepping up to a heavy-duty class, keeping the cost and profile appropriate for standard cabinet work. Designers and contractors specifying individual drawers for remodels also use this slide when replacing older undermounts in existing frameless casework — the zinc finish and ball-bearing action hold up in long-term residential service. Because this is sold as a single right-hand cabinet member, shops building out a run of drawers can order left and right members in the quantities the job calls for rather than buying pre-bundled pairs.

Frequently Asked Questions

The Right Slide, Built Right Into the Cabinet

Pair this right-hand Quadro V6 member with its left-hand counterpart, build the drawer box to spec, and the result is a full-extension, soft-closing undermount drawer that stays hidden and performs drawer after drawer.