Hettich Quadro V6 Undermount Drawer Slide for Deep, Full-Access Drawers

This Hettich Quadro V6 left-hand undermount drawer slide delivers full extension with integrated soft-close in a 580mm nominal length, making it a strong match for deeper kitchen, bath, and furniture drawers where complete rear access and a controlled, quiet close matter.

Key Features

• Full extension brings the entire drawer out to the cabinet face so the back of the box is fully reachable.
• Integrated soft-close catches the drawer near the end of travel and settles it shut silently without a damper add-on.
• 90 lb weight capacity per pair handles a fully loaded kitchen drawer with confidence.
• Ball bearing construction rolls smoothly and stays precise through repeated daily cycles.
• Left-hand orientation — this is the cabinet-side member for the left side of the drawer; pair it with the matching right-hand slide to complete the installation.
• Zinc finish protects the steel members through years of indoor cabinet service.

Built for Deeper Drawer Runs

At 580mm nominal length (22-13/16 inches), this slide is sized for drawers in deeper cabinets — think standard kitchen base cabinets, bathroom vanities, and furniture pieces where a shorter slide would leave the back of the box stranded inside the cabinet. Full extension means when the drawer is pulled, the entire interior clears the face frame, so nothing is buried at the rear. The minimum installation depth is 23-13/16 inches, so measure the interior cabinet depth before ordering to confirm clearance behind the slide.

The soft-close mechanism is built into the slide, not retrofitted. Push the drawer in and it slows on its own over the last inch, landing quietly every time. For frameless cabinet installations, the slide mounts directly to the cabinet side panel — no rear brackets required.

Steel, Ball Bearings, and a Zinc Finish Built for the Long Run

The Quadro V6 runs on ball bearings between formed steel raceways, which keeps the pull smooth and consistent even when the drawer carries a heavy load. Steel construction throughout gives the slide the rigidity to hold that 90 lb rating per pair across repeated open-close cycles. The zinc finish protects against the everyday humidity of a kitchen or bath environment and keeps the slide looking clean inside the cabinet — relevant when open cabinetry or a contrasting drawer box puts the hardware in view.

Drawer side thickness compatibility spans 1/2 inch to 5/8 inch (maximum 5/8 inch), so this slide works with both 1/2 inch and standard 5/8 inch drawer sides. Build the drawer box to the Hettich Quadro V6 specification for length, width, and rear notching — undermount slides require the box to be sized to the slide's published dimensions, not just cut to a nominal depth.

The Right Fit for Frameless Production and Custom Cabinet Work

The Quadro V6 is designed for frameless cabinets, where it mounts directly to the interior side panel on the 32mm system grid. It suits cabinet shops running frameless kitchen and bath lines, custom furniture makers building drawer-heavy pieces, and contractors installing new cabinetry where a concealed, soft-close undermount is in the specification. Because this is a left-hand member sold individually, it fits the workflow of shops ordering handed components separately by the piece to match run quantities — order one left-hand and one right-hand member for each drawer.

Common Questions

A Full-Access, Quiet-Close Slide Ready for Deep Cabinet Work

The Hettich Quadro V6 at 580mm puts full extension and integrated soft-close where deeper drawers need it most — bring the whole drawer out, close it quietly, and move on to the next one.