Hettich Quadro V6 Undermount Slide For Deep Frameless Drawers

The Hettich Quadro V6 is a right-hand, full-extension undermount drawer slide rated 90 lb, built for 600mm (23-5/8 inch nominal) drawer boxes in frameless cabinets. Integrated soft-close damping and four-way front adjustment make it a capable choice where clean lines and precise door alignment both matter.

Key Features

• Full extension brings the entire drawer out to the cabinet face, putting the back of the box within reach.
• Integrated soft-close catches the drawer near the end of travel and settles it shut without slamming.
• 90 lb weight capacity handles fully loaded kitchen and bath drawers with room to spare.
• Four-way (4D) front adjustment lets installers fine-tune the drawer front in height, side, depth, and tilt after hanging.
• Ball bearing construction delivers smooth, consistent travel under load cycle after cycle.
• Right-hand orientation — pair with the matching left-hand member to complete a drawer installation.

Built for Deep Kitchen and Bath Drawers

At 600mm, this is the slide length that suits a standard 24-inch base cabinet. The nominal drawer length is 23-5/8 inches, and the minimum installation depth is 24-5/8 inches, so it drops into a typical frameless base cabinet without any modification to the cabinet box. Full extension means every inch of that deep drawer is reachable at full open — useful for pots-and-pans drawers, deep utensil pulls, and linen or bath storage where rear access is part of the daily routine.

Precision Hardware in a Zinc Finish

Steel ball bearings in full-length raceways carry the 90 lb load smoothly and hold tolerance over the long run. The zinc finish protects the steel members through years of indoor service without adding bulk. The slide accepts drawer sides from 1/2 inch to 5/8 inch thick, giving shops some flexibility in box construction — but the drawer box must be built to the Hettich Quadro specification, including the correct width, rear notch, and any required drilling for the locking device. A box built to the wrong dimension will not seat correctly on the runners.

Right for Frameless Production Shops

This slide is engineered for frameless cabinet construction, where the panel face is flush and slides mount directly to the interior side. The 4D locking device on the Quadro V6 lets the installer adjust the front after the drawer is hung — height, side, depth, and tilt — which cuts rework time when fitting a run of identical base cabinets. Cabinet shops running 24-inch frameless boxes as part of a production line will find the consistent 600mm nominal length keeps ordering straightforward. This is a single right-hand slide; order one left-hand member alongside it to make a complete working pair.

The Right Slide for the Job

When the cabinet is frameless, the box is 600mm deep, and the front needs to land straight the first time, the Quadro V6 does the work — full extension, soft-close, and four-direction adjustment built in.