Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 22 inch side-mount ball bearing drawer slide from Fulterer, rated 198 lb, with over-travel extension and a zinc finish built for indoor service. It is the right choice when a drawer needs to clear a countertop overhang or a deep face frame and carry a serious load doing it.
A standard full-extension slide stops at the cabinet face. When a countertop overhangs the opening — or when a deep face frame eats into the available reach — the rear of the drawer stays out of easy reach. Over-travel solves that by carrying the drawer member past the nominal slide length so the back of the box clears the obstruction. At 198 lb capacity, this slide handles the loads that rule out standard cabinet slides: a tool drawer packed with hand tools, a deep storage drawer loaded with hardware, or a workbench pull-out carrying clamps and jigs. The 22 inch length suits cabinets built for standard kitchen or shop depth, pairing well with drawer boxes in the 20 to 22 inch range.
The slide is formed from steel and finished in zinc — the standard protective coating for side-mount ball bearing slides intended for indoor use. Zinc plating resists the everyday moisture and humidity found in a shop or kitchen environment without adding visual weight to the installation. Because the slide sits beside the open drawer box rather than beneath it, the finish stays largely out of sight in use. This is a functional, durable coating chosen to last, not to decorate. It is not a stainless finish and is not rated for wet, washdown, or outdoor environments.
The combination of over-travel and a 198 lb rating targets a specific buyer: someone building or equipping a cabinet where ordinary slides fall short on either reach or capacity. Cabinet shops adding tool storage to bench runs, contractors installing heavy utility drawers under overhanging counters, and homeowners building out a serious garage or workshop are the most common fits. Because the slide is non-handed, there is no sorting by side at installation — order the quantity your drawer count requires and mount them straight from the box. For face-frame cabinet installations, rear mounting support is needed at the back of the slide; add the appropriate series-matched rear brackets, sold separately.
No. Twenty-two inches is the closed length of the slide. Over-travel means the drawer member extends past that nominal length, so the actual travel is slightly greater — the drawer pushes beyond the cabinet face by the over-travel amount. Slide length and drawer travel are two separate specs.
This is a standard-motion slide — no soft-close damper, no self-close spring, and no detent. The drawer stays wherever it is left. If a closing feature matters for the application, look at the soft-close or hold-in variants in the Fulterer line.
No. The non-handed design means one part fits either side of the drawer. Order two of this same SKU for a complete drawer installation.
Yes, but face-frame cabinets require rear support at the back of the slide because the cabinet side is set back from the frame. Add the appropriate rear mounting brackets for this series — they are sold separately and are series-specific.
Side-mount ball bearing slides in this class nominally require 1/2 inch of clearance per side. Build the drawer box 1 inch narrower than the cabinet opening to accommodate both slides. Confirm the precise tolerance for the FR 5000 series against the Fulterer installation spec before cutting your box.
When the application calls for a drawer that clears an overhang and carries real weight, this zinc Fulterer over-travel slide delivers both without compromise — sized at 22 inches and rated for the work that exceeds standard cabinet hardware.
Sold In: 1 Pair
