Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 24 inch over-travel side-mount ball bearing drawer slide is built for heavy storage and shop drawers that sit beneath overhanging worktops. Rated 198 lb per pair, it carries serious loads and pushes the drawer past full extension so the back of the box clears a deep countertop edge or face frame.
A standard full-extension slide brings the drawer to the cabinet face — enough for most kitchen work, but not for a drawer mounted under a deep countertop overhang or behind a thick face frame. The over-travel action on this slide carries the drawer box that extra distance so the very back of the drawer is exposed and reachable. For a garage workbench with a heavy overhang, a shop base cabinet beneath a solid top, or a file drawer behind a built-up face frame, that added travel is what makes the difference between a drawer that works and one that makes you dig.
Cold-formed steel members run on hardened steel ball bearings, delivering the rigidity a 198 lb load demands. The bright zinc electroplate is the workhorse finish for indoor side-mount slides — protective, durable, and unobtrusive beside the open drawer. Zinc is an indoor finish; it is not rated for wet, washdown, or exterior environments.
Cabinet shops and contractors fitting out base cabinets under thick stone or butcher-block tops will find the over-travel solves the overhang problem without custom workarounds. Shop builders loading base cabinet drawers with heavy tooling or hardware are served by the 198 lb rating at this length. The non-handed format also makes it a clean choice for production runs where a single SKU covers every drawer position in a cabinet line. This is a standard-motion slide — no detent, soft-close, or self-close — so if the application calls for a closing feature, a different variant in this family fits that need.
No. 24 inches is the closed length of the slide. Because this is an over-travel slide, the drawer actually travels past that length — beyond full extension — so the opening distance exceeds the nominal slide length. The exact over-travel distance is not stated in the source data; contact the vendor for the measured travel figure if that spec is critical to your layout.
Side-mount ball bearing slides in this class typically require 1/2 inch of clearance per side between the drawer box and the cabinet interior. Build the drawer box 1 inch narrower than the cabinet opening to hit that target. Confirm the exact tolerance against Fulterer's installation spec for this series before cutting the box.
Side-mount slides need rear support in face-frame construction because the cabinet side is set back from the face frame. Use the appropriate rear mounting brackets for your installation. Brackets for this series are sold separately and are series-specific — do not assume compatibility with brackets from other brands.
No. This is a standard-motion slide: no damper, no spring, and no detent. The drawer stays wherever it is left. If you need soft-close or a hold-in feature, other variants in this family offer those options.
Please confirm the sold-as unit on the product page before ordering. Slides in this segment are typically sold as a pair, but verify against the listing so you receive the right quantity per drawer.
At 198 lb capacity and over-travel extension in a zinc-finished, non-handed format, this Fulterer 24 inch slide handles the combination of heavy load and counter overhang that trips up a standard cabinet slide — keeping the job moving without a second trip to the hardware aisle.
Sold In: 1 Pair
