Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The US Futaba DynaSlide is a 12 inch side-mount ball-bearing drawer slide with over-travel and a hold-in feature, rated 100 lb per pair. Built for the shorter drawer applications where over-travel matters most — compact utility cabinets, bench pedestals, and shop carts — it pushes the drawer member past full extension so rear contents clear deep face frames and overhangs without needing a longer slide to get the job done.
At 12 inches, this is the shortest over-travel slide in the DynaSlide program, and that is exactly the point. In a deep face-frame cabinet or a bench unit with a countertop overhang, a short drawer is often the hardest to reach because the opening geometry leaves the rear contents blocked. Over-travel solves that by driving the drawer member past the slide body so the entire drawer clears the opening. The result: the back of a compact utility drawer, small parts bin, or pedestal file drawer becomes fully accessible without pulling the drawer off its slides. This is also the right choice for mobile carts and shop cabinets where a short, stout slide handles the load and the hold-in feature keeps the drawer shut when the cart is in motion.
The DynaSlide members are formed steel with a zinc finish. Zinc plating is the standard indoor corrosion-resistance treatment for ball-bearing drawer slides, and it carries this one reliably through shop and commercial service. The finish is practical, not decorative — these slides are hidden inside the cabinet when the drawer is closed. At 100 lb per pair, fastener selection matters: drive screws into solid cabinet material and size them to the slide's mounting holes for the full rated capacity. Side clearance for this series is not listed in the available product data, so confirm the required gap from the US Futaba DynaSlide specification sheet before sizing the drawer box.
This slide fits woodworkers, cabinet shops, and contractors building or repairing compact cabinets where drawer depth runs short but load and access still count. Bench pedestals, small parts storage, service cart drawers, and office pedestal files are natural applications. The hold-in feature makes it a sensible pick for any mobile unit — shop carts, rolling tool storage, or portable service cabinets — where drawers that walk open during transit are a nuisance. It also works in fixed cabinetry wherever a 12 inch slide length suits the drawer depth and over-travel provides the access a plain full-extension slide would not.
Per pair, which is the standard basis for drawer slide load ratings. One pair of slides — one on each side of the drawer — carries 100 lb combined.
No. The hold-in is a mechanical detent that resists the drawer drifting or bouncing open. A normal pull releases it. For a positive lock that requires a deliberate lever release, a lock-in/lock-out slide is the right product.
The over-travel dimension for this specific DynaSlide model is not published in the available data. Contact US Futaba or request the DynaSlide spec sheet for the exact extension-past-full figure before finalizing a design that depends on clearing a specific overhang depth.
No. The motion is hold-in only — no damper and no self-close ramp. The drawer stays wherever it is left once past the detent's capture zone.
Side-mount slides in face-frame cabinets typically need rear mounting brackets to support the back of the slide, because the cabinet side is set back from the face frame. Confirm whether DynaSlide-compatible rear brackets are required for your specific installation before ordering.
When the drawer is compact but the load and access requirements are not, the 12 inch US Futaba DynaSlide over-travel slide delivers a 100 lb class rating and full rear access in the form factor that fits the cabinet — not the other way around.
Sold In: 1 Set
