Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The US Futaba DynaSlide is a 26 inch side-mount ball-bearing drawer slide with over-travel extension and a hold-in detent, designed for heavy shop, garage, and commercial utility drawers that carry meaningful loads and need the full drawer interior within reach.
A 26 inch slide is a long one, and the drawers it lives in tend to be deep: tool chests under bench overhangs, wide storage drawers behind a face frame, service carts where the back compartment needs to come fully clear. Standard full-extension stops at the cabinet face, which is often enough for kitchen drawers but falls short when a countertop lip or a deep frame blocks the opening. Over-travel carries the drawer a step further so the entire box — including the rear compartment — is out and reachable without unloading the front half first. The hold-in detent adds practical value in any setting where drawers get shut firmly or the cabinet moves: it catches the drawer at closed and holds it there until a deliberate pull opens it.
The DynaSlide members are formed steel, running on steel ball bearings in full-length raceways. The zinc finish provides the corrosion resistance needed for indoor shop and commercial environments — a functional choice rather than a decorative one. These slides are built to work under load, not to show in an open cabinet. At this length and load class, fastener quality matters: mount the slides into solid material with screws sized to the mounting holes, and the rated capacity holds through regular service cycles.
Specify the 26 inch DynaSlide for deep shop drawers, utility cabinets, and commercial casework where a 100 lb class rating and over-travel access are the selection criteria. The non-handed design speeds installation on multi-drawer cabinets because there is only one part to stock. The hold-in feature makes it a practical choice for mobile carts and service cabinets that get rolled around or opened hard. This is a side-mount slide requiring standard 1/2 inch clearance per side, so size the drawer box 1 inch narrower than the cabinet opening to leave the correct gap on each side.
Per pair — the standard basis for drawer slide load ratings. Each pair of slides supports up to 100 lb of drawer and contents combined.
No. The hold-in is a detent, not a lock: it resists the drawer drifting or bouncing back open and releases with a normal pull. For a drawer that must stay positively latched, you would need a lock-in/lock-out slide.
The product data confirms over-travel extension; the precise over-travel distance beyond the 26 inch nominal length is not stated in the available specification data. Confirm against the US Futaba DynaSlide series spec sheet before sizing a cabinet with tight rear clearance.
Screws are not noted as included. Order fasteners appropriate to the slide's mounting hole size and the cabinet material alongside your slides.
The zinc finish is suited to dry indoor service. For wet, washdown, or outdoor applications, specify a stainless steel slide instead.
When the drawer is deep and the load is real, over-travel and a hold-in detent are the two features that keep work moving — the drawer comes all the way out when you need it, and stays shut when you don't.
Sold In: 1 Set
