Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The US Futaba DynaSlide is a 100 lb class side-mount ball-bearing drawer slide with over-travel and a hold-in feature, built in a 14 inch length for drawers where shorter cabinet depth meets a serious load requirement.
Most over-travel heavy-duty slides start conversations around 18 or 20 inch lengths, but shallower cabinets have their own load demands. A 14 inch DynaSlide suits tool drawers in compact shop carts, short-depth base units, workbench drawers under enclosed undershelves, and utility drawers in mobile service cabinets where there simply is not enough room for a longer slide. At 100 lb per pair, it handles a full set of sockets, a loaded tray of fasteners, or dense parts storage without the flex and binding that an undersized slide produces. The over-travel means the rear of the drawer, not just the front half, is reachable — useful when the drawer is deep enough to swallow small parts at the back.
Steel members with a zinc finish provide corrosion protection suited to indoor shop and commercial environments. The zinc plating is a functional choice on a working slide, not a decorative one, and it holds up to the daily cycling a busy service drawer gets. Ball bearings run in formed steel raceways along the full member length, keeping movement precise and load distribution even across the travel. The hold-in detent is mechanical, releases with a normal pull, and adds no moving parts beyond what the bearing system already carries.
The DynaSlide 14 inch is the right call for cabinet shops and contractors building compact utility and tool storage where the drawer is short but the load is not. It fits shop carts, mobile tool cabinets, and underslung workbench drawers that get opened dozens of times a day under real weight. The non-handed design speeds up installation in production runs — no sorting, no mislabeled sides. For contractors outfitting a service vehicle with shallow cabinet bays, the hold-in feature keeps drawers shut on the road without any add-on hardware.
Per pair — the standard basis for drawer slide load ratings. One pair of DynaSlide 14 inch slides carries up to 100 lb of drawer and contents combined.
Over-travel pushes the drawer member past the slide length so the entire drawer box, including the back, clears the cabinet face. In a short, deep drawer this means you can reach rear contents without unloading the front first.
No. It is a detent that resists the drawer drifting or bouncing open, and it releases with a normal pull. For a positive lock that requires a deliberate lever release, look at a lock-in/lock-out slide.
Side clearance for the DynaSlide series is not confirmed in the available data, so verify the gap requirement against the US Futaba specification sheet before sizing your drawer box. Standard side-mount ball-bearing slides typically need 1/2 inch per side, but confirm for this series before cutting.
No. The motion is hold-in only, with no damper. The drawer stays where you leave it after the hold-in detent releases, with no assisted closing in either direction.
When the cabinet is compact but the contents are not, the DynaSlide 14 inch gives you over-travel reach and 100 lb class capacity in a length that actually fits the job.
Sold In: 1 Set
