Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-8 series is a 12 inch side-mount ball bearing drawer slide machined from 304 stainless steel, rated 107 lb per pair, with a hold-in anti-rebound detent that keeps the drawer shut in applications where moisture, humidity, or washdown exposure would corrode a zinc-finished slide.
A zinc-plated slide handles dry indoor cabinetry reliably, but it is not the right call when the environment fights back. Commercial kitchens, food-prep stations, marine galley cabinetry, laboratory casework, and outdoor bar drawers all see the kind of moisture, cleaning chemicals, or salt air that corrodes zinc plating over time. The ESR-8's 304 stainless steel body takes that exposure without rusting through. The hold-in detent also earns its keep in these settings — on a boat or in a busy prep kitchen, a drawer that stays where it is pushed is a practical asset, not just a convenience feature.
Every member of the ESR-8 slide is 304 stainless steel — the alloy widely used in food-service equipment, marine fittings, and medical cabinetry for its chromium content and resistance to oxidation. The finish is the natural brushed appearance of the alloy itself, not a coating applied over a less resistant base metal. Ball bearings run in formed stainless raceways for consistent, load-bearing travel across the 12 inch slide length.
This is the right slide for builders and specifiers working in environments where a standard zinc or epoxy-finished slide would degrade. Marine cabinetmakers, commercial kitchen fabricators, laboratory furniture shops, and residential builders finishing outdoor kitchens or wet-bar cabinetry all reach for 304 stainless when the spec calls for corrosion resistance. At 107 lb per pair on a 12 inch slide, it also suits compact but heavily loaded drawers — spice pullouts next to a commercial range, tooling drawers in a stainless workbench, or utility drawers in a food-prep island. Because the design is non-handed, one part number covers both sides of the drawer, which simplifies procurement in production work.
For most compact and utility drawers, yes. At 3/4 extension the front three-quarters of the drawer box comes fully clear of the opening — the rearmost few inches stay inside the cabinet. If complete access to the back of the drawer is critical, look at the full-extension version in this series.
It is a mechanical catch that holds the drawer in the closed position until intentionally pulled open. There is no spring assist and no damping — the drawer stays put rather than drifting or bouncing back after a firm close. It is not a soft-close or a locking feature.
Side-mount ball bearing slides in this class require nominally 1/2 inch of clearance per side between the drawer box and the cabinet interior. Confirm the ESR-8 series specification against the Sugatsune catalog before sizing your drawer box, as the exact tolerance for this series is not stated in the available source data.
304 stainless steel offers strong general corrosion resistance and is widely used in marine interior applications. For exposed saltwater or offshore marine environments, 316 stainless is the more common specification. Use this slide in protected marine interiors and confirm the grade requirement with your project specs.
Verify the sold-as unit before ordering — confirm whether this SKU ships as a pair or as a single slide member, as the source data does not explicitly state the unit.
Where moisture and corrosion are part of the job, specifying a stainless slide from the start saves rework later. The Sugatsune ESR-8 in 304 stainless brings ball bearing smooth travel, a stay-closed detent, and genuine corrosion resistance to any drawer that needs to perform past the limits of a standard zinc finish.
Sold In: 1 Each
