Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-8 series 14 inch side-mount ball bearing drawer slide is built from 304 stainless steel for applications where zinc-finished steel is not enough — food-service installations, marine cabinetry, medical environments, and anywhere moisture, cleaning agents, or humid air would corrode a standard slide. The slide is sold as a pair, non-handed, with 3/4 extension and a hold-in anti-rebound detent, rated 103 lb per pair.
Zinc-plated ball bearing slides perform well in dry indoor cabinetry, but they are not the right choice when the environment fights back. The ESR-8's 304 stainless steel members hold up in commercial kitchens where steam and cleaning products are constant, in marine and coastal installations where salt air attacks exposed metal, and in medical or laboratory casework where hygiene standards require a finish that survives repeated chemical wipe-downs. The hold-in anti-rebound detent adds practical value in these settings — a drawer that bounces back open in a galley or a prep kitchen is a safety and workflow problem the detent solves without any mechanism complexity.
304 stainless steel is the workhorse alloy of the food-service and marine hardware industries: strong, weldable, and resistant to oxidation across a wide range of environments. On the ESR-8, both the cabinet member and drawer member are stainless steel, so there is no mixed-metal corrosion risk from a zinc slide body paired with a stainless bracket. Ball bearings run in formed steel raceways the full length of the slide for smooth, rattle-free travel. This is a functional slide finish in the truest sense — it performs in conditions that would visibly degrade a plated surface within months.
The ESR-8 in 14 inches suits shorter drawers in demanding settings: undercounter prep drawers in commercial kitchens, storage drawers in marine berths and yacht galleys, utility drawers in medical carts or lab casework, and any dry-goods or tool drawer in a space that sees regular washdown. The 3/4 extension keeps the rear of the drawer inside the cabinet — a practical trade-off in applications where full rear access is secondary to a lower price point and a smaller footprint behind the drawer. If every inch of the drawer must be reachable, a full-extension slide is the better fit; if the application is tough on hardware and the front two-thirds of the drawer covers day-to-day needs, the ESR-8 delivers the stainless build without the cost of over-engineered extension travel.
Zinc plating resists light moisture but deteriorates quickly in sustained salt-air and marine environments. Stainless steel is the correct choice for boat and coastal installations where the hardware is exposed to humidity, spray, or salt over time.
It is a mechanical catch that holds the drawer in the closed position and prevents it from bouncing back open after being pushed shut firmly. There is no spring assist and no damping — the drawer stays put until pulled open intentionally.
Approximately three-quarters of the drawer length clears the cabinet opening. The rear portion of the drawer box remains inside the cabinet — that is a design characteristic of 3/4 extension, not a defect. If complete access to the back of the drawer is required, a full-extension model is the correct choice.
No. The ESR-8 is non-handed, so both slides in the pair are identical. Order one pair per drawer.
The ESR-8 follows the standard side-mount ball bearing clearance of 1/2 inch per side. Build the drawer box 1 inch narrower than the cabinet opening to accommodate both slides.
When the installation calls for a slide that survives what zinc cannot, the Sugatsune ESR-8 in 304 stainless delivers the load capacity, smooth travel, and stay-closed reliability that demanding casework requires — without swapping in an overbuilt or overpriced solution.
