Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The GSlide G-Slide is a 20 inch full-extension side-mount ball bearing drawer slide, rated 100 lb per pair, with a hold-in anti-rebound detent that keeps the drawer firmly closed until you pull it open. It is a practical, specification-grade choice for shop, office, and utility cabinets where drawers must not drift or bounce back after being shut.
In a busy shop, van, or utility room, drawers get pushed shut hard. Without a hold-in detent, a loaded drawer can rebound an inch or two and sit half-open. The G-Slide's mechanical catch engages when the drawer closes and holds it in place until you pull it with intent. This is not a soft-close damper and not a spring-assist close — the drawer does not pull itself shut. It rides freely on ball bearings and stays exactly where you leave it, whether that is open or closed. For cabinets where slam-and-bounce is the problem, this detent solves it without adding the cost or complexity of a motion mechanism.
Cold-formed steel members carry a zinc finish across the slide's full length. Zinc is the working standard for this class of ball bearing slide: it resists the light surface oxidation that comes with years of indoor use in kitchens, offices, and shops. The slide is functional hardware — it sits beside the open drawer box rather than behind it — so the finish is about durability, not decoration. Zinc-finished steel is rated for dry indoor environments.
The G-Slide 20 inch is well matched to kitchen base cabinets, workshop tool drawers, office utility cabinets, and garage storage where full access to the back of a loaded drawer matters. The 100 lb per pair rating handles a typical loaded utility drawer without running near its limit. Because the design is non-handed, a shop or installer can pull pairs from stock without sorting, and the lever disconnect allows the drawer to be removed for delivery or cleaning without tools. For face-frame cabinet installations, rear mounting brackets are required to support the back of the slide — brackets are series-specific and sold separately.
The detent is a mechanical catch that holds the closed drawer in place and prevents it from bouncing back open after being pushed shut. It does not pull the drawer closed on its own — there is no spring assist — and it does not slow or dampen the closing motion. It simply holds the drawer where it lands.
No. 20 inches is the closed length of the slide. Because this is a full-extension slide, the drawer member travels approximately the full slide length, bringing the entire drawer out to the cabinet face. Slide length and drawer travel are two separate measurements.
The G-Slide requires 1/2 inch of side clearance per side. Build the drawer box 1 inch narrower than the cabinet opening to account for both slides.
No. The G-Slide is non-handed — both slides in the pair are identical and fit either side of the drawer. Order by quantity, not by orientation.
Yes, but face-frame construction requires rear mounting brackets to support the back end of the slide, since the cabinet side is set back from the face frame. Brackets are sold separately and must match the G-Slide series.
The GSlide G-Slide 20 inch gives you complete drawer access and a drawer that stays put — a straightforward combination that works across kitchen, shop, and office builds without overcomplicating the hardware spec.
Sold In: 1 Set
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  GY4340RB Mfr# GS4340 RB | GSlide Rear Mounting Bracket, GS4340 RB |
