Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This 22 inch side-mount ball bearing drawer slide from GSlide's G-Slide series combines full-extension travel with a hold-in anti-rebound detent, rated 100 lb per pair, in a non-handed zinc-finished steel design built for shop, utility, and office drawers where a closed drawer needs to stay that way.
A standard-motion slide leaves the drawer wherever it stops. A self-close spring pulls it shut. The hold-in anti-rebound detent on this slide does something different: it catches the drawer at the closed position and holds it there until you pull it open intentionally. Push the drawer shut firmly and it stays — no bounce-back, no slow drift back open. That behavior matters in shop drawers that get closed with a bump of the hip, utility cabinets that take vibration from nearby equipment, and office storage where an open drawer is a hazard. This is not a soft-close slide and it is not a self-close slide; the detent holds, it does not slow or pull. The drawer stays where you put it.
The G-Slide series runs steel ball bearings in formed steel raceways across the full length of both members, delivering smooth and consistent travel under load. The zinc finish is the working standard for side-mount ball bearing slides: functional indoor corrosion protection on a slide that is visible alongside the open drawer box, not concealed behind it. Steel construction keeps the slide within its 100 lb per pair rating through repeated daily cycles without flex. This is an indoor slide for dry cabinet environments.
The 22 inch length suits deeper cabinet drawers — a good match for base cabinets, workbench drawers, and storage units where a shorter slide would leave usable depth behind. At 100 lb per pair, the capacity covers most shop and office loading without stepping into a heavy-duty slide. Specify this slide when the drawer content is dense enough to drift or bounce the drawer back open on a plain slide, but the project does not call for soft-close or self-close action. It also fits face-frame cabinets with the appropriate rear mounting brackets, which are sold separately and are series-specific.
It catches the drawer at the fully closed position and holds it there mechanically. Push the drawer shut and it stays shut — it will not spring back or drift open. It does not pull the drawer closed the way a self-close spring does, and it does not slow the drawer the way a soft-close damper does. Pull the drawer open normally and the detent releases.
No. 22 inches is the closed length of the slide. Because this is a full-extension slide with an intermediate member, the drawer travels approximately its full nominal length and the entire drawer clears the cabinet opening. Slide length and drawer travel are two separate specs.
No. The G-Slide series is non-handed, so both slides in the pair are identical. Order the quantity that matches your drawer count and install one on each side without sorting.
Yes, but face-frame installations require rear mounting brackets to support the back end of the slide where the cabinet side is set back from the face frame. Rear brackets are sold separately; use brackets matched to this series.
Build the drawer box 1 inch narrower than the cabinet opening to leave 1/2 inch of side clearance for each slide, one per side. This is the standard side clearance for this segment.
The GSlide G-Slide 22 inch slide gives shop builders, cabinet makers, and contractors a full-extension, 100 lb rated slide with a real stay-closed feature — no damper to wear out, no spring to fatigue, just a solid mechanical detent that does one job well and keeps doing it.
Sold In: 1 Set
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  GY4340RB Mfr# GS4340 RB | GSlide Rear Mounting Bracket, GS4340 RB |
