Thick Door Geometry And Half Overlay Fit

This Salice Series 200 Silentia hinge is built specifically for thick cabinet doors hung at a half overlay, with integrated soft-close and a 94 degree opening angle engineered to let a thick door clear the cabinet front without binding.

Key Features

• Thick door cup geometry seats the 35mm cup at the depth a thick door needs to clear the cabinet opening cleanly.
• Silentia integrated soft-close damps the door over the final closing arc so it settles quietly without slamming.
• 94 degree opening angle is the correct swing for a thick door, sized to clear the cabinet front without collision.
• Half crank arm positions the door at a half overlay, the geometry for partial-overlay doors and pairs sharing a center partition.
• Screw-on mounting fastens directly to the cabinet with wood screws, no clip-on plate engagement required.
• Fits both frameless and face-frame cabinets when paired with the matching Salice base plate, sold separately.

Where the 94 Degree Angle and Thick Door Cup Earn Their Place

A standard concealed hinge is sized for doors roughly 16 to 22mm thick. Push past that range and the cup does not seat correctly, or the door collides with the cabinet side as it swings. This hinge addresses both problems: the cup depth accommodates the thicker door, and the 94 degree opening arc is calibrated so that extra door mass clears the cabinet front at full swing. That reduced angle is not a shortcoming, it is the engineering that makes a thick door work without binding. The 35mm cup bores into the back of the door, and the hinge body screws to a Salice base plate on the cabinet, which is ordered separately as its own SKU.

Steel Build and a Quiet Close That Stays Reliable

The hinge is plated steel finished in nickel. Silentia soft-close is integrated into the hinge body, so no separate damper clip is needed. That matters especially on thick doors, which carry more mass and hit harder when they close without damping. The Silentia mechanism takes that impact out of every close. Side and height adjustment lets you bring a run of thick-door panels back to an even reveal as the cabinet settles over time, without pulling the hinge off the plate to do it.

The Right Buyer for This Hinge

This hinge is for cabinet makers and finish carpenters working with thick door stock on either frameless or face-frame boxes. It covers the half overlay position, so it suits both single partial-overlay doors and pairs of doors meeting on a shared center partition. If the project uses standard 16 to 22mm doors instead of thick stock, a standard Salice Series 200 hinge is the correct choice. And if the install calls for full overlay rather than half, the full overlay version of this series is the one to pull. Plate selection should match the cabinet construction and the Salice Series 200 family; plates from other brands will not connect to this hinge.

Common Questions

Thick Doors That Close Quietly and Sit Square

Specify this hinge when thick door stock meets a half overlay layout and the job calls for a close that is quiet every time, on either cabinet construction.