Nickel Thick Door Hinge for Half Overlay Face-Frame and Frameless Cabinets

This Salice Series 200 hinge is built specifically for thick doors, delivering a self-close, half overlay installation on both face-frame and frameless cabinets, with dowel mounting for CNC and production workflows.

Key Features

• Thick door engineering accommodates doors that exceed the standard 16 to 22mm range where a conventional hinge cup would not seat correctly.
• Self-close spring draws the door shut automatically over the final degrees of travel.
• Half overlay, half crank arm positions the door at a partial overlay, suited to two doors sharing a center partition or standard partial-overlay layouts.
• 94 degree opening angle is the correct swing geometry for thick doors, allowing clearance without collision against the cabinet front.
• Dowel mount cup presses into pre-bored dowel holes for fast, accurate positioning in CNC production environments.
• Three-way adjustment provides height and side movement after the door is hung, so reveals can be dialed in across a run.

Where Thick Doors and Partial Overlay Meet

A standard concealed hinge is sized for doors in the 16 to 22mm range. When a door runs thicker than that, the cup geometry and arm clearances need to be matched to the added material. This hinge handles that application on both frameless and face-frame cabinets, setting the door at a half overlay where it covers part of the cabinet side. That half overlay position is the right call wherever two doors share a single center partition, each overlapping their side of it, or wherever the cabinet design specifies a partial reveal rather than a full cover. The 35mm cup bores into the back of the thick door, and the arm connects to a Salice base plate mounted to the cabinet, which is sold separately. Plates are Salice-specific; plates from other brands will not connect to this hinge.

Steel Build in a Nickel Finish

The hinge body is steel with a nickel finish, consistent with the rest of the Series 200 line so finish matching across a job is straightforward. The 94 degree opening is not a restriction to work around. It is the correct engineering for a thick door: that angle lets the door swing clear of the cabinet front without the added material creating a bind. The side and height adjustment built into the arm lets you square up doors and achieve an even reveal after installation, which matters most when thick doors are used across multiple cabinets in a run.

The Right Fit for Production and Custom Work

The dowel mount is the detail that sets this hinge apart for CNC shops and production environments. The cup carries pre-attached dowels that press into bored holes in the door without cup screws, keeping the line moving when doors are being processed in volume. For custom shops and contractors fitting thick-panel doors on face-frame or frameless boxes, the same dowel mount gives a clean, repeatable installation. This hinge is for thick doors specifically. For doors in the standard thickness range, a conventional Series 200 hinge is the right choice. For a cushioned, damped close rather than a spring pull, the Silentia+ soft-close version of this series is the alternative to specify.

Common Questions

Thick Doors, Hung Right, Across the Whole Job

When the design calls for thick-panel doors at a half overlay, this Salice Series 200 hinge delivers the correct geometry, a self-close spring, and a production-ready dowel mount in a nickel finish that coordinates with the rest of the run.