Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 10 inch full-extension side-mount ball bearing drawer slide is built for shallow cabinet drawers where smooth, reliable travel and a stay-closed detent matter as much as load capacity. Rated 100 lb per pair, it runs on steel ball bearings and carries a zinc finish that handles daily indoor use without fuss.
A 10 inch slide is the right call for narrow cabinets, shallow spice pull-outs, small parts organizers, and utility drawers built into tight spaces. Full extension is especially valuable at this length — the difference between reaching the back of a 10 inch drawer and digging blind is whether the drawer comes all the way out to the cabinet face. The hold-in anti-rebound detent adds practical value in these compact installs, where a lightly loaded drawer can bounce back open on a firm close without a detent to stop it.
The slide members are cold-formed steel with a zinc electroplate — the workhorse finish across the side-mount ball bearing segment. Zinc protects the steel through years of indoor cycling and blends with painted, melamine, and plywood interiors without drawing attention. It is a functional finish on hardware that sits beside the open drawer, not a decorative coating, and it is not rated for outdoor, wet, or high-humidity environments.
Cabinet shops and finish carpenters building shallow drawers into islands, base cabinets with limited depth, and built-in furniture pieces will find the 10 inch length fills the gap between the typical 12 inch minimum and a true compact drawer. Homeowners retrofitting a small cabinet or replacing a worn slide in a tight pull-out are equally well served. Because the slide is non-handed and rated at the standard 100 lb class, it fits standard cabinetry workflow without special ordering or left-right inventory management. In face-frame cabinets, rear mounting brackets are needed to support the back end of the slide — those brackets are series-specific and sold separately.
No — 10 inches is the closed length of the slide. Because this is a full-extension slide, the drawer member travels approximately the full slide length, bringing the whole drawer box out to the cabinet face. Slide length and travel are two separate specs.
The detent is a mechanical catch that holds the drawer in the closed position after it is pushed shut, stopping it from bouncing back open. It does not pull the drawer closed on its own, and it does not damp the close — it simply holds. If you need the drawer to pull itself shut, look at a self-close slide instead.
Each slide requires 1/2 inch of clearance between the drawer box side and the cabinet interior. Build the drawer box 1 inch narrower than the cabinet opening to leave the required clearance for both slides.
No. The slide is non-handed, so both pieces in the pair are identical. Order one pair per drawer.
It can, but face-frame installations require rear mounting brackets to support the back end of the slide where the cabinet side is set back from the frame. Those brackets are series-specific and sold separately — confirm the correct bracket for this Fulterer series before ordering.
Compact drawers deserve the same smooth action and dependable close as every other drawer in a cabinet run — this 10 inch zinc slide delivers both without adding complexity to the order or the install.
Sold In: 1 Pair