Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 26 inch full-extension side-mount ball bearing drawer slide is rated 100 lb per pair and built with a hold-in anti-rebound detent that keeps the drawer closed until pulled — no bounce-back, no drift. A practical choice for kitchen drawers, shop cabinets, and utility storage where the drawer needs to stay put after closing.
A 26 inch slide suits deeper cabinet runs — full-depth base cabinets, tall utility units, and shop storage where drawer boxes run 24 to 26 inches front to back. At full extension the entire drawer clears the cabinet face, giving unobstructed access to the rear of the box. The hold-in anti-rebound detent earns its place in that same context: a deep, loaded drawer shutting with any force behind it will rebound without a detent to catch it. This slide stops that rebound at the closed position, so the drawer stays shut until intentionally pulled open. Note that the detent does not pull the drawer closed, and it does not damp the closing motion — this is a standard-motion slide with a mechanical hold.
The slide members are cold-formed steel with a zinc electroplate finish. Zinc is the workhorse finish for side-mount ball bearing slides: it resists corrosion in dry indoor environments, keeps the steel members protected through years of daily cycles, and presents a consistent, low-key appearance beside the drawer box. It is a functional finish, not a decorative one — the slide sits in the cabinet, mostly out of view when the drawer is closed. For installations where a darker finish matters visually, a black-finish variant exists in the same family.
The 26 inch length and 100 lb per pair rating make this slide a natural match for full-depth base cabinet drawers — pots, pans, and heavy kitchen storage — and for shop and garage cabinets where tool drawers run deep and carry real weight. Because the slide is non-handed, a single part number covers both sides of the drawer; no separate left and right SKUs to track. Mount position is side mount with 1/2 inch of clearance per side, so the drawer box is built 1 inch narrower than the cabinet opening. In face-frame cabinets, rear mounting brackets are required to support the back end of the slide; those brackets are series-specific and sold separately. The slide is sold as a pair.
The hold-in anti-rebound detent is a mechanical catch that holds the drawer closed and prevents it from bouncing back after a firm close. It does not slow or damp the closing motion. Soft-close uses a damper to slow the drawer over the last inch of travel and settle it shut quietly. This slide has the detent only — no damper, no soft-close.
26 inches is the closed length of the slide. Because this is a full-extension slide, the drawer member travels approximately the full slide length, bringing the entire drawer out to the cabinet face. Slide length and travel are the same only on full-extension models — this is one of them.
No. The slide is non-handed, so both pieces in the pair are identical and either one fits either side of the drawer. Order one pair per drawer.
The slide requires 1/2 inch of side clearance per side. Build the drawer box 1 inch narrower than the cabinet opening to leave the correct gap for each slide.
Yes, but face-frame construction requires rear mounting brackets to support the back end of the slide — the cabinet side is set back from the frame and cannot support the slide without them. Rear brackets for this series are sold separately; confirm the correct bracket for the Fulterer FR 5000 family before ordering.
Pair the 26 inch length with the hold-in anti-rebound detent and the result is a full-extension ball bearing slide built for the drawers most likely to rebound — deep, loaded, and closed with purpose. Solid zinc-finished steel, 100 lb per pair, non-handed, and ready to install on 1/2 inch of clearance per side.
Sold In: 1 Pair