Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 24 inch full-extension side-mount ball bearing drawer slide from Fulterer, rated 100 lb per pair, with a hold-in anti-rebound detent and a bright zinc finish that disappears against standard cabinet interiors.
At 24 inches, this slide suits deeper drawers: base cabinet pots-and-pans drawers, deep utility drawers in a shop or garage, and storage drawers in built-ins where the contents need to be fully reachable. Full extension means the drawer member travels its full length, clearing the cabinet face completely so every inch of the drawer box is accessible. The hold-in detent is the right choice for drawers that get closed with some force — the detent catches the drawer and holds it, stopping the rebound that leaves a drawer sitting ajar after a bump or an accidental hard close.
The slide is cold-formed steel with a zinc electroplate finish. Zinc is the working standard for side-mount ball bearing slides: durable enough for years of indoor cycling, resistant to the humidity common in kitchens and utility spaces, and low-profile enough to stay out of sight beside the open drawer box. This is not a decorative finish, and it is not rated for outdoor or wet-environment use. For installations where the slide finish is visible and needs to coordinate with hardware, the zinc tone reads as a clean, neutral metallic.
Cabinet shops running production on frameless or face-frame boxes will find the non-handed design straightforward to stock and install. Contractors and remodelers who need a dependable 24 inch full-extension slide for kitchen or utility work get honest capacity in a standard format. Homeowners replacing worn slides or upgrading from 3/4-extension rollers will notice the difference immediately: full extension on a 24 inch drawer brings the back of a deep cabinet drawer within reach without stooping. In face-frame cabinets, rear mounting brackets are required to support the back of the slide; those brackets are series-specific and sold separately.
No. The hold-in anti-rebound detent is a mechanical catch that holds the drawer closed and prevents it from bouncing back open. There is no damper and no spring assist. The drawer does not ease itself shut — you close it, and the detent holds it. Soft-close is a separate feature that uses a damper to slow the drawer over the last inch of travel.
Build the drawer box 1 inch narrower than the cabinet opening to leave the required 1/2 inch side clearance for each slide. Fulterer does not publish a maximum drawer width for this series in the available data; for very wide drawers, verify the application with Fulterer's published specs before ordering.
Yes, but face-frame installations require rear mounting brackets to support the back end of the slide. The cabinet side is set back from the face frame, so the slide needs that rear support. Brackets for this series are sold separately and are series-specific.
Extend the drawer fully and use the slide's disconnect lever to release the drawer member from the cabinet member. The drawer pulls free without tools.
The listing is for a pair of slides — one for each side of the drawer. Order one pair per drawer.
A 24 inch full-extension slide with a hold-in detent and honest 100 lb capacity covers the majority of deep cabinet and utility drawer applications. Install it once and the drawer works the same way ten years later as it does on day one.
Sold In: 1 Pair