Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 22 inch full-extension side-mount ball bearing drawer slide delivers smooth, reliable travel with a hold-in anti-rebound detent that keeps the drawer shut until intentionally pulled. Rated 100 lb per pair in a bright zinc finish, it is a practical workhorse for kitchen, office, shop, and utility drawers where the drawer needs to stay closed — not bounce back.
A loaded utility drawer pushed firmly shut has momentum. Without a detent, that momentum can bounce the drawer back open an inch or two — enough to be a nuisance in a busy shop or kitchen. The hold-in anti-rebound feature on these Fulterer slides seats the drawer fully at close and resists rebound until the next intentional pull. That makes them a smart fit for workshop benches, garage storage, home office base units, and kitchen drawers that see hard, frequent use. This is a standard-motion slide with no spring assist and no damper — the drawer stays wherever it is left, open or closed, until moved.
The slide members are cold-formed steel running ball bearings in full-length raceways. Zinc plating is the segment's standard functional finish: it protects the steel through years of indoor service and stays low-profile beside an open drawer. This is not a decorative finish and not a stainless slide — it is sized for dry indoor installations.
These slides suit cabinet shops and contractors running standard drawer-box builds where full extension and a 100 lb per pair rating cover the load requirement, and where a stay-closed detent solves a real-world need. Build the drawer box 1 inch narrower than the cabinet opening to leave the required 1/2 inch clearance per side. The non-handed format simplifies ordering on multi-drawer jobs — one SKU covers every position. In face-frame cabinets, rear mounting brackets are required at the back of the slide; those brackets are series-specific and sold separately. For frameless installations, the slide mounts directly to the cabinet side panel.
No. The hold-in anti-rebound detent is a mechanical catch that holds the drawer firmly shut and prevents it from bouncing back open. There is no damper and no spring — the drawer does not slow or pull itself closed. If you need a damped, quiet close, look at the Fulterer soft-close series instead.
Full extension means the drawer member travels approximately the full slide length, bringing the entire drawer box out to the cabinet face. The 22 inch measurement is the closed slide length, not a travel limit — on a full-extension slide those numbers are effectively the same.
No. This slide is non-handed — both slides in a pair are identical. One SKU covers both sides of the drawer.
Side-mount slides need support at the rear end inside a face-frame cabinet. Rear mounting brackets handle this — they are series-specific and sold separately. In frameless cabinets, the slide screws directly to the cabinet side panel and no extra brackets are needed.
This listing is for one pair of slides, which is the complete set for one drawer.
When a standard full-extension ball bearing slide is not quite enough because the drawer keeps drifting or bouncing back, the Fulterer 5266's hold-in detent closes the gap — without adding soft-close complexity or cost.
Sold In: 1 Pair