Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This 18 inch full-extension side-mount ball bearing drawer slide from Fulterer is rated 100 lb per pair and comes in a bright zinc finish, making it the straightforward workhorse choice for cabinet shops, kitchen projects, and utility installs where a clean, corrosion-resistant steel slide is the right call. A hold-in anti-rebound detent keeps the drawer firmly closed between uses without any spring or damper mechanism.
The hold-in anti-rebound detent makes this slide a natural fit for drawers that see frequent, forceful closing — shop benches, utility rooms, office storage, and kitchen pot drawers where contents shift and a closed drawer should stay closed. At full extension, every inch of the drawer interior is accessible, so deep drawers pulling out from tall base cabinets or shop carts earn their floor space. Because the slide is a standard-motion design with no self-close spring, it also works cleanly in setups where push-to-open mechanisms will be added later, since there is no closing ramp to work against.
Cold-formed steel members run on full-length ball bearing raceways for smooth, consistent travel under load. The zinc electroplate finish is the segment standard for indoor corrosion resistance — it is not a decorative or stainless coating, but it protects the steel reliably through years of dry interior service. The zinc tone is neutral and largely out of sight once the drawer is in place, which makes it a practical pairing with any cabinet interior color.
Cabinet shops running production kitchens will find the non-handed format reduces pick errors and speeds installation — pull two slides from the box and mount them without checking orientation. Contractors sourcing for multi-drawer base cabinets get a consistent 100 lb, full-extension spec across every opening. Homeowners doing a single kitchen refresh can size the drawer box confidently using the 1/2 inch clearance per side and know the detent will keep the drawer closed even in a busy kitchen. This slide is for dry, indoor work only; it is not rated for wet, exterior, or washdown environments.
A self-closing slide uses a spring to pull the drawer shut once pushed past the capture point. This slide has no spring — the hold-in detent is a mechanical catch that keeps the drawer closed after you push it shut yourself. It stops bounce-back, but it does not assist closing.
Build the drawer box 1 inch narrower than the cabinet opening to leave 1/2 inch of clearance for each slide. That is the required side clearance per side for this slide.
No. The design is non-handed — both slides in the pair are the same part, so you can pull them straight from the box without sorting.
Yes, but face-frame construction requires rear support at the back of the slide. Add series-matched rear mounting brackets, sold separately, to carry the slide's back end inside a face-frame cabinet.
The 18 inches is the closed length of the slide. Because it is full extension, the drawer member travels approximately the full slide length, bringing the entire drawer out to the cabinet face — but slide length and travel are two separate facts. Match the slide length to your drawer depth and cabinet interior depth, not to a desired travel distance.
Order a pair per drawer, confirm your drawer depth against the 18 inch slide length, and size the box 1 inch under the opening — the zinc finish, full extension, and hold-in detent do the rest.
Sold In: 1 Pair