Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Knape and Vogt TRU-TRAC 100B series is a 10 inch full-extension side-mount ball bearing drawer slide rated 100 lb per pair, finished in zinc for straightforward indoor cabinet work where a clean, functional hardware look is the goal.
A 10 inch slide is the right choice for shallow drawers: spice pull-outs, bathroom vanity drawers, small utility cabinets, and desk drawers where the interior depth runs under a foot. Full extension matters here because a shallow drawer that only opens three-quarters of the way leaves precious little room to reach the back. The zinc finish earns its place in spaces where the hardware blends into the surrounding cabinetry rather than calling attention to itself — frameless Euro-style boxes and painted face-frame cabinets alike. Standard motion means there is no soft-close damper and no spring-close ramp: the drawer rides the bearings and stays exactly where you leave it, which suits pull-outs that are opened and closed frequently by hand.
The slide members are cold-formed steel, and the zinc plating provides the corrosion resistance expected for dry indoor environments. Zinc is the working standard finish in this slide segment: it protects the steel through years of daily cycling, keeps the slide profile low-profile and neutral in color, and holds up to the humidity typical of a kitchen or bathroom cabinet. This is a functional finish, not a decorative one — it does its job quietly beside the drawer box where it is rarely seen once installed.
Cabinet shops running production on small-drawer cabinets, vanities, or bathroom furniture will find the bulk-pack format practical for stocking the install bench. The non-handed slide simplifies the process further: pull from one bin, cut no lefts or rights, and install straight through a run of identical drawers. The 1/2 inch side clearance per side is the standard for this class of slide, so drawer boxes sized on that formula drop in without adjustment. For face-frame cabinets, rear mounting brackets are required to support the back of the slide; those brackets are sold separately and are series-specific, so confirm compatibility before ordering.
No. Ten inches is the closed length of the slide. Because this is a full-extension model, the drawer travel is approximately the full slide length — the entire drawer box clears the cabinet opening — but slide length and drawer travel are two separate specifications.
No. This is a standard-motion slide with no closing mechanism. The drawer stays wherever it is left. If damped or spring closing is needed, look for the soft-close or self-close variants in this series.
Build the drawer box 1 inch narrower than the cabinet opening to allow the required 1/2 inch side clearance for each slide. The manufacturer's recommended maximum drawer width for this series should be confirmed in the current KV catalog before sizing wide boxes.
No. The TRU-TRAC 100B is non-handed, so both slides in a pair are identical. Order the quantity you need and install without sorting.
Yes, but you will need rear mounting brackets to support the back of the slide, since the cabinet side is set back from the face frame. Those brackets are sold separately and must match this series.
The TRU-TRAC 100B in zinc gives small-drawer installations a full-extension, 100 lb rated slide that installs quickly, stores efficiently in bulk, and finishes clean — exactly what a production run of shallow cabinets calls for.
Sold In: 1 Set
