Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Knape and Vogt TRU-TRAC 100 series is a 28 inch full-extension side-mount ball bearing drawer slide rated 100 lb per pair, finished in zinc for lasting indoor service. It brings the entire drawer out to the cabinet face on every open, making the back of a deep kitchen, shop, or utility drawer fully reachable.
A 28 inch slide is the right call when the cabinet is deeper than a standard 24 inch base — think island base cabinets, lower utility cabinets in a garage shop, or the deep storage run under a workbench. Full extension is what makes a deep drawer practical: at 28 inches of slide length, the drawer box clears the cabinet entirely, so a cook reaching for a Dutch oven or a contractor pulling pipe fittings from the back row does not have to dig. The standard motion means the drawer rests wherever it is pushed; if the application calls for a self-close spring or a soft-close damper, there are other slides in this family for that.
The zinc plating on these steel members is the segment's proven workhorse finish — it resists the humidity and cleaning products typical of kitchen and shop environments, and it does it without adding visible hardware to the cabinet interior. Zinc reads as a bright, neutral silver against melamine, plywood, or painted cabinet sides. It is a functional indoor finish; for wet, marine, or washdown environments, a stainless slide is the right choice instead.
Cabinet shops running deep base cabinets reach for the 28 inch length when the 22 or 24 inch standard does not fill the box. Contractors sourcing for kitchen installs and homeowners building out a garage storage wall both land here when the drawer depth and a 100 lb working load are the two numbers that need to match. The bulk pack suits shops pulling multiple pairs at a time — confirm your drawer count and order accordingly. In face-frame cabinet construction, rear mounting brackets are required to support the back end of the slide; those brackets are sold separately and are series-specific.
The 28 inch measurement is the closed length of the slide, not the travel distance. Because this is a full-extension slide, the drawer member travels approximately the full slide length, bringing the entire drawer box out to the cabinet face — but the slide length and the drawer travel are two distinct specs.
No. This is a standard-motion slide. There is no soft-close damper, no self-close spring, and no hold-in detent. The drawer stays in the position where it is left. If a closing feature is needed, other variants in this family offer those options.
The TRU-TRAC 100 series recommends a maximum drawer width of 24 inches. For wider drawers, a heavier-duty series is the better fit.
No. The slide is non-handed — both pieces in the pair are identical and either one installs on either side of the drawer. Order one pair per drawer.
Yes, but face-frame construction requires rear mounting brackets to support the back end of the slide, since the cabinet side is set back from the face frame. Those brackets are sold separately; confirm the matching bracket for this series before ordering.
When the cabinet is deeper than standard and the drawer needs to pull out completely, the 28 inch TRU-TRAC 100 in zinc delivers the length, the load rating, and the full-extension travel to keep the job moving.
Sold In: 1 Set
