Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Knape and Vogt TRU-TRAC 100B is a 26 inch full-extension side-mount ball bearing drawer slide rated 100 lb per pair, finished in zinc for years of indoor service. It is a straightforward, well-built choice for kitchen drawers, shop cabinets, and utility storage where full access to the back of the drawer matters and a clean zinc finish disappears against the interior.
A 26 inch slide length suits deeper cabinet runs — full-depth base cabinets, storage drawers in a shop credenza, and utility cases where a shorter slide would leave drawer capacity on the table. Full extension means the whole drawer comes out to the cabinet face, so nothing stays buried at the back. This is a standard-motion slide: no soft-close, self-close, or detent. The drawer rides the bearings and stays wherever it is left, which is exactly right for drawers that get opened and closed dozens of times a day by a shop crew that does not need a mechanism getting in the way. For face-frame cabinets, add rear mounting brackets at the back of the cabinet — the slide needs that rear support, and those brackets are sold separately.
Cold-formed steel members run on ball bearings in full-length raceways, giving the slide smooth, consistent travel even when the drawer is loaded toward its rated capacity. The zinc finish is electroplated over steel — the standard protection for side-mount slides in dry indoor environments. It is a functional finish that resists corrosion through years of kitchen and shop use, not a decorative one. The slide sits beside the open drawer box and is mostly hidden in use, so the zinc finish does its job without needing to look polished.
Cabinet shops running base cabinet production and contractors fitting out utility rooms or workshop storage will get the most from this SKU. The 26 inch length and 100 lb rating cover the wide majority of residential and light-commercial base cabinet drawers, and the bulk carton format suits any operation going through multiple pairs per day. Homeowners fitting out a single cabinet can order here too — the non-handed design and standard 1/2 inch clearance make installation uncomplicated. This slide is for indoor work only; zinc plating is not a substitute for stainless or coated hardware in wet or exterior applications.
No. 26 inches is the closed length of the slide. Because this is a full-extension design, the drawer travels approximately the full slide length, bringing the entire drawer out to the cabinet face — but slide length and drawer travel are two separate measurements.
This SKU is Bulk-Pack, meaning the slides ship loose in a carton. Confirm the pack quantity shown on the product page before ordering to know how many pairs you are adding to the cart.
No. The TRU-TRAC 100B is non-handed, so both slides in any pair are identical. Order the quantity you need without worrying about matching left and right parts.
Yes, with the right rear support. In face-frame construction the cabinet side is set back from the face frame, so the back of the slide needs a rear mounting bracket. Those brackets are sold separately and are series-specific — make sure you source the correct bracket for the 100B series.
No. This is a standard-motion slide with no closing mechanism. The drawer stays open or closed wherever you leave it. If you need damped soft-close closing on the same 1/2 inch clearance format, look at the KV FM soft-close series instead.
The TRU-TRAC 100B in zinc gives you full drawer access, a proven 100 lb rating, and the standard zinc finish that survives daily shop and kitchen use without asking for attention — a solid working slide for any project where those specs are what the job calls for.
Sold In: 1 Set
