Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 20 inch side-mount ball bearing drawer slide is built for drawers that carry real weight and need to clear an overhang. Rated 198 lb per pair in a zinc-finished steel body, it travels 1 inch past full extension and locks the drawer closed with a hold-in anti-rebound detent when not in use.
Most drawers stop at the cabinet face when fully open. Under a countertop overhang or behind a thick face frame, that means the back of the drawer stays out of easy reach. The 1 inch over-travel on this slide pushes the drawer past the opening so the full depth is accessible without reaching. It is the right choice for workshop storage under a workbench, utility drawers beneath a kitchen counter overhang, and any cabinet drawer where the last few inches of depth matter. The hold-in anti-rebound detent adds a practical benefit in shop and garage settings: a loaded drawer pushed shut stays shut rather than drifting back open when the bench vibrates.
The zinc plating over cold-formed steel is the workhorse finish for side-mount ball bearing slides. It resists the humidity and grime of an interior shop or kitchen environment without any extra treatment. Zinc is not a decorative finish and is not rated for outdoor or wet environments, but for the enclosed cabinet applications this slide is designed for, it provides consistent long-term protection. The slide sits alongside the open drawer rather than beneath it, so the finish does its job quietly out of sight.
At 198 lb per pair, this slide handles loads that would stress a standard 100 lb cabinet slide. Shop drawers carrying tools, utility cabinets loaded with hardware, and workbench drawers under heavy-use counters are all good matches. The non-handed format means one SKU covers both sides of any drawer without separate left and right orders. For face-frame cabinet installations, plan for rear mounting support at the back of the slide, as the cabinet side is set back from the frame. Rear mounting brackets for face-frame work are sold separately and are series-specific.
No. Twenty inches is the closed length of the slide. Because this is an over-travel slide, the drawer member actually travels the slide's full length plus 1 additional inch, so the drawer clears the cabinet face by that extra inch. Slide length and drawer travel are two separate specs.
No. The hold-in anti-rebound detent is a mechanical catch that keeps the drawer closed and stops it from bouncing back open. It does not slow or damp the closing motion. This is a standard-motion slide with a stay-closed detent, not a soft-close or self-close slide.
No. The slide is non-handed, so both pieces in the pair are identical. Order one pair per drawer regardless of orientation.
It can, but face-frame construction sets the cabinet side back from the front frame, so the back end of the slide needs rear mounting support. Rear brackets are not included and must be ordered separately. Make sure the brackets are compatible with this slide series before ordering.
This SKU is sold as a pair — one pair of slides per drawer.
A 198 lb rating, 1 inch of over-travel past the cabinet face, and a hold-in detent that keeps the drawer put — this Fulterer zinc slide is a practical answer for shop drawers, utility cabinets, and any install where the counter gets in the way.
Sold In: 8 Set
