Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Fulterer 28 inch over-travel side-mount ball bearing drawer slide is rated 198 lb per pair and travels 1 inch past full extension, making it the right choice when a standard-length slide leaves the back of a deep or heavily loaded drawer just out of reach. It ships in a bright zinc finish that blends into the cabinet interior and protects the steel through years of hard indoor use.
The combination of a 198 lb capacity and 1 inch of over-travel addresses two problems at once. A drawer carrying tools, hardware, or heavy stock is difficult to unload when the back half stays hidden inside the cabinet at full open. Over-travel pushes the box past the cabinet face so the entire drawer bottom is visible and reachable without leaning in. This matters most under a countertop overhang, behind a deep face frame, or in a tall shop cabinet where the drawer opening sits above eye level. The hold-in detent adds a practical note: once a heavy drawer is pushed shut, the mechanical catch keeps it there so it does not drift or rebound open on an uneven floor or workbench.
The slide members are cold-formed steel with a bright zinc electroplate. Zinc is the segment's standard indoor corrosion-resistant finish — functional rather than decorative, and appropriate for cabinetry where the slide sits beside the drawer box and is not on display. The ball bearings run in formed steel raceways the full length of the slide, which keeps the load distributed evenly across the travel and prevents point wear over long service. This is not a stainless or powder-coated finish and is not specified for wet, washdown, or outdoor environments.
Cabinet shops and contractors building shop cabinets, tool storage, garage cabinetry, or heavy utility drawers will find the 198 lb rating and 28 inch length suited to boxes that go well beyond standard kitchen-drawer loads. Designers specifying frameless production cabinets with deep drawers benefit from the over-travel when the design calls for a countertop or frame overhang. The non-handed, 1/2 inch side clearance format matches the standard side-mount installation routine, so it drops into an existing workflow without additional measuring or hardware. For face-frame cabinets, rear mounting brackets are required at the back of the slide and are sold separately — they are series-specific, so confirm the bracket matches this Fulterer model before ordering.
That is the rating per pair — both slides working together. Do not double the number by counting each slide separately.
No. The hold-in anti-rebound detent is a mechanical catch, not a damper. It holds the drawer closed and prevents bounce-back after a firm push, but it does not slow or cushion the closing motion. This is a standard-action slide with no soft-close damping.
The drawer member travels 1 inch past the slide's nominal length. That extra inch clears overhanging countertops and deep face frames so the back of a 28 inch drawer is fully accessible.
No. The slide is non-handed — both pieces in the pair are identical and fit either side of the drawer box.
Face-frame cabinets require rear mounting brackets to support the back end of the slide. Those brackets are sold separately and are series-specific to Fulterer, so verify compatibility before ordering.
A 28 inch over-travel slide at 198 lb per pair covers the cases where a standard cabinet slide simply is not enough — the drawer is too heavy, the box is too deep, or the opening is too tight to reach the back. Add the hold-in detent and the zinc finish, and this is a workhorse slide ready for a demanding shop or storage application.
Sold In: 6 Set
