Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Knape and Vogt SF Series sink tip-out tray converts the narrow false front below a kitchen or bathroom sink into a shallow storage compartment, keeping small items close at hand and out of sight when the panel is closed.
The panel beneath most kitchen sinks is a decorative false front with nothing behind it. This tray clips into that space and turns it into a shallow pull-out compartment sized for the items that always end up on the counter or in the back of the sink basin. Sponges, scrubbers, and soap pads fit naturally. The tab stop holds the tray at the open position so nothing spills forward when the front is pulled down.
Stainless steel is the right call for a tray that lives immediately below the sink. The material resists the moisture, splashes, and humidity that accumulate in that cabinet zone over time, and it wipes clean without absorbing odors. The SF22W finish presents a neutral, professional look that blends with painted, stained, or stainless-fronted cabinetry without drawing attention to itself.
This is the right tray for a kitchen remodel or an existing renovation where the sink run has a standard-width false front and the homeowner or installer wants to capture every usable inch of storage. Cabinet shops building sink bases for kitchens, wet bars, or prep areas can spec this tray knowing the stainless finish will hold up through daily use. At 23-5/8 inches, it fits a false front opening sized for that length. Check the clear width of the false front opening before specifying, since tip-out trays are length-sensitive and a tray that does not span the opening correctly will not mount squarely.
The tab stop is a built-in limit that keeps the tray from tipping fully forward when you open it. It holds the tray at a controlled angle so the contents stay in place and do not fall out.
The SF22W is the tray itself. Hinge and mounting hardware for tip-out trays are sold separately in the SF Series line. Confirm the compatible hardware with the series listing before ordering.
For a location that sees constant moisture, stainless steel holds up better than painted or coated finishes that can chip or absorb water over time. That is why this material is the practical choice for sink tip-out applications specifically.
This tray is 23-5/8 inches long. Measure the clear usable length of your false front opening and confirm it matches before ordering. Tip-out trays are not adjustable in length.
The SF22W puts a stainless steel tray behind a false front that was doing nothing, with a tab stop that keeps it controlled every time it opens.
Sold In: 1 Each
