KV8407 20" Full Extension Hold-in anti-rebound Ball Bearing Drawer Slides, Unhanded Side Mount Zinc Bulk-Pack - 8407B 20

Knape & Vogt Ball Bearing Drawer Slides Built for High-Volume Cabinet Work

This is a 20 inch full-extension side-mount ball bearing drawer slide from Knape & Vogt's 8407 series, rated 100 lb per pair with a hold-in anti-rebound detent and a zinc finish built for steady indoor production use. It arrives in a bulk pack, making it the practical choice for cabinet shops running drawers by the dozen.

Key Features

• Full extension brings the entire drawer out to the cabinet face so nothing at the back stays out of reach.
• Hold-in anti-rebound detent keeps the closed drawer from bouncing back open after a firm push-shut.
• 100 lb rating per pair covers loaded kitchen, utility, and shop drawers comfortably within the standard cabinet duty class.
• Non-handed design means the same slide fits either side of the drawer, with no left/right sorting on the bench.
• Zinc finish on cold-formed steel delivers consistent corrosion resistance across every slide in a production run.
• Bulk-Pack quantity reduces per-unit cost and keeps drawers moving on high-volume installs.

Where This Slide Does Its Best Work

The 8407 series earns its place in production cabinet shops where drawers are built and installed in volume. Full extension means a homeowner or end user can reach the back of a kitchen drawer without digging, which matters as much in a renovation spec as it does in a builder-grade run. The hold-in anti-rebound detent adds a quality-feel detail that prevents the drawer from rebounding when shut firmly, a common complaint on plain free-sliding slides in busy households. At 20 inches, this slide suits standard base cabinet drawers and deeper utility or pantry drawers where the cabinet interior depth supports the length. It is a standard-motion slide: no self-close spring, no soft-close damper. The drawer stays wherever it is left, and closing is purely by hand.

Materials, Finish, and Indoor Durability

Cold-formed steel members carry the load through the ball bearing raceways, and the zinc finish provides the corrosion resistance expected of a production drawer slide used indoors. Zinc is the working standard for side-mount ball bearing slides in cabinet and millwork applications. It is a functional finish, mostly hidden beside the open drawer box, so its job is protection and consistency across a run rather than appearance. These slides are for dry, indoor installations — the zinc finish is not rated for exterior, marine, or high-humidity environments.

The Right Fit for Shops Ordering in Volume

Cabinet shops and contractors sourcing for multiple installs benefit most from the bulk-pack format, which reduces packaging overhead and keeps slides ready at the bench. Designers specifying hardware for a full kitchen run can call this slide for any standard base cabinet drawer up to the 100 lb class. The non-handed, lever-disconnect design keeps installation straightforward: no sorting, no separate left and right part numbers, and drawer removal is handled at the slide without special tools. In face-frame cabinet construction, rear mounting brackets are required at the back of the slide to support it where the cabinet side is set back from the frame — those brackets are sold separately and are series-specific to the 8407 line.

Common Questions

Built for the Work That Does Not Stop

The Knape & Vogt 8407 series in zinc gives production shops a full-extension, hold-in, 100 lb rated slide they can pull from stock, install without sorting, and trust to perform across an entire kitchen or multi-room project.