Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The US Futaba NJ-31733 series delivers a 20 inch side-mount ball-bearing drawer slide that combines over-travel extension with integrated soft-close damping, rated 100 lb per pair. Sold in a box of 10 pairs, it suits commercial and production cabinetry where both reach and controlled closing matter.
Over-travel earns its place anywhere a drawer sits behind an overhang or a deep face frame. When the rear of the drawer has to clear the front edge of the cabinet to be reachable, a full-extension slide falls short — the back stays inside the opening. This slide pushes the drawer beyond that point so rear contents come all the way out. Pair that travel with soft-close damping and you get controlled closing even on a fully loaded drawer, which matters in kitchens with stone countertop overhangs, workbenches with thick front rails, and commercial millwork where slam damage adds up over time.
The members are formed steel with a zinc finish — durable for indoor service, resistant to the light moisture and dust of a production shop or commercial kitchen. Ball bearings run in precision raceways the full length of the slide, keeping the pull consistent as load shifts toward the front of the drawer at full extension. The soft-close mechanism is integrated into the slide body; no add-on damper clips to source or lose.
Cabinet shops running production kitchens and commercial casework reach for this slide when a drawer needs to clear an overhang and the client expects soft-close. At 100 lb per pair it covers most residential and light commercial loads — pots-and-pans drawers, media pulls, and utility storage. The 10-pair box format suits shops ordering by the job rather than by the pallet, and the non-handed design means one SKU covers every position in the cabinet.
Per pair, the standard basis for drawer slide load ratings. One pair of slides carries 100 lb.
Side clearance for the NJ-31733 series is not confirmed in the available data — check the US Futaba specification sheet before sizing the drawer box. Standard side-mount ball-bearing slides typically require 1/2 inch per side, but verify against this model's spec before building.
The damper is rated for the slide's 100 lb capacity, so it is engineered to control a loaded drawer. A drawer near the top of that range will close more firmly than a light drawer, but the mechanism is designed to handle the full rated load.
Each box contains 10 pairs — enough for 10 complete drawers.
Side-mount slides install in both face-frame and frameless cabinets. In face-frame construction, the rear of the slide needs support — rear mounting brackets or a face-frame adapter — because the cabinet side is set back from the frame. Source the appropriate rear hardware before installing in face-frame work.
When the project calls for over-travel access and soft-close finishing in one slide, the US Futaba NJ-31733 series at 20 inches handles it at a 100 lb class rating — production-ready in a 10-pair box.
Sold In: 1 Pair