Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This US Futaba 28 inch ball-bearing drawer slide combines over-travel extension with soft-close motion, delivering a drawer that clears past the cabinet face and settles silently shut. Rated 100 lb per pair and sold in a 10-pair box, it suits the cabinet shop or contractor outfitting a run of utility, shop, or commercial drawers in a single order.
Over-travel is the right call anywhere a drawer sits under a countertop overhang, behind a deep face frame, or in a tall cabinet where the back of the drawer would otherwise stay out of reach. At 28 inches, this slide suits full-depth base cabinets, deep tool and parts drawers, and commercial casework where a standard-length slide would leave the rear contents buried. The soft-close damper pairs naturally with that application: a heavy, fully extended drawer settling shut quietly is less likely to jar contents or rack a lightly built case than one that slams home. The 10-pair box format makes this a practical choice when outfitting a whole bank of drawers in one order.
The slides are steel with a zinc finish, the standard corrosion-resistant surface for ball-bearing drawer slides in indoor service. Steel ball bearings run in formed raceways along the full length of the members, keeping the pull smooth and consistent even when the drawer is near its rated load. The non-handed design means no left and right members to sort — the same slide mounts on either side of the drawer box.
Cabinet shops building utility, shop, or commercial casework in volume are the natural fit here. The 10-pair box keeps the job moving without repeated small orders, and the 28 inch length covers full-depth drawers in standard base and tall cabinet applications. Contractors and millwork operations specifying a single slide for a mixed run of heavy utility drawers — where both over-travel access and soft-close finish are on the requirement list — will find the combination practical rather than premium-priced. These are indoor slides; for wet, washdown, or exterior applications, a stainless-steel or corrosion-rated product is the right choice.
Per pair — that is the standard basis for drawer slide load ratings in this category. One pair of slides supports up to 100 lb of drawer and contents combined.
The over-travel distance is not stated in the available product data. Confirm the exact travel figure against the US Futaba NJ-31733 series specification sheet before sizing for a tight overhang clearance.
Side clearance for this series is not listed in the available data. Standard side-mount ball-bearing slides typically need 1/2 inch per side, but confirm against the US Futaba spec sheet before sizing the drawer box.
The 10-pair box contains the slides only; screws are not listed as included. Order appropriate mounting fasteners separately and size them to the slide's mounting holes for full load-rated performance.
Side-mount ball-bearing slides can be used in face-frame cabinets, but the cabinet side is set back from the face frame — rear mounting brackets or sockets are typically needed to support the back of the slide. Check your cabinet construction and add the appropriate rear support hardware if required.
Ten pairs of 28 inch over-travel soft-close slides means the whole drawer bank goes in on one order, every drawer reaches the back, and every close lands without a slam.
Sold In: 1 Pair