GSlide 10-Pair Box 22" Hold-In/Anti-Rebound Side Mount Over-Travel 90 lb Ball Bearing Drawer Slide, Zinc, GS4205 22

Zinc Ball Bearing Drawer Slide Built for Drawers That Need to Clear the Overhang

This is a 22 inch side-mount ball bearing drawer slide from GSlide's G-Slide series, rated 90 lb per pair, with 1 inch of over-travel and a hold-in anti-rebound detent that keeps the drawer firmly closed between uses.

Key Features

• 1 inch of over-travel carries the drawer past the cabinet face, clearing countertop overhangs and deep face frames so the full drawer interior is reachable.
• Hold-in anti-rebound detent stops the drawer from bouncing back open after a firm close — no spring assist, no damping, just a reliable mechanical catch.
• 90 lb weight capacity per pair handles loaded kitchen, utility, or shop drawers at the standard side-mount duty class.
• Steel ball bearings in full-length raceways deliver smooth, consistent travel through the full over-travel stroke.
• Non-handed design means both slides in the pair are identical — no left/right sorting before installation.
• Zinc finish provides standard indoor corrosion protection on the steel members.

Where the Extra Inch of Travel Matters

Most full-extension slides bring the drawer out to the cabinet face and stop there. Under a countertop overhang or behind a deep face frame, that stopping point can still leave the rear of the drawer partially blocked. The G-Slide's 1 inch of over-travel pushes the drawer member past the nominal slide length, so the back corners of the drawer clear the obstruction and come into reach. It is the right choice for kitchen base cabinets under thick stone tops, for desks and workbenches with a protruding front edge, or for any drawer where a standard full-extension slide leaves you fishing for what is in the back.

The hold-in anti-rebound detent rounds out the closing behavior: push the drawer shut and a mechanical catch holds it there. The drawer does not drift open and does not rebound after a confident close. This is not a soft-close damper and not a self-close spring — the drawer stays exactly where you put it and releases with a normal pull.

Steel Construction and Zinc Finish

The slide members are formed steel with a zinc electroplate finish. Zinc is the working standard for side-mount ball bearing slides in cabinetry and furniture applications — it resists the routine humidity and handling of indoor environments and keeps the steel protected through years of drawer cycles. The finish is functional rather than decorative; the slides sit alongside the drawer box and are largely out of sight in normal use. For outdoor, wet, or washdown environments, a stainless or coated alternative is the appropriate choice.

Who This Slide Is For

Cabinet shops and contractors who regularly work with thick-top kitchen installations will find the over-travel spec solves a recurring layout problem without requiring a custom solution. Designers specifying base cabinets under quartz or granite should confirm the overhang depth against the 1 inch over-travel to make sure it is sufficient. Homeowners replacing existing hardware in a built-up-top kitchen can swap in these slides without changing the drawer box, provided the current box was built for 1/2 inch side clearance per side. The 90 lb per pair rating covers standard kitchen and utility drawer loads comfortably; if the application calls for loaded file drawers or heavy shop drawers well above that threshold, step up to a higher-rated class.

The slide is non-handed and mounts to the drawer side and cabinet interior on standard 1/2 inch side clearance. In face-frame cabinets, rear mounting brackets are required to support the back end of the slide — brackets are series-specific and sold separately.

The Right Slide for the Right Job

When the layout calls for a drawer that clears the overhang and stays put when closed, the GSlide G-Slide over-travel slide delivers both in a non-handed, zinc-finished steel package sized for the standard side-mount install.