Right-Hand Precision And A Short-Drawer Fit

The Hettich Actro 5D is a soft-close, full-extension undermount drawer slide engineered for the right-hand side of a drawer pair. This 300mm runner is the member you need when ordering individual handed components — suited to shallow drawers in frameless cabinetry with drawer sides between 1/2 inch and 5/8 inch thick.

Key Features

• Right-hand orientation — this is a single cabinet member for the right side of the drawer; pair it with the matching left-hand runner to complete one drawer.
• Soft-close motion — an integrated damper slows the drawer over the last inch of travel for a quiet, controlled close.
• Full extension — the drawer member travels the full slide length, bringing the entire drawer box out to the cabinet face.
• 88 lb load capacity — rated per pair, the Actro 5D handles a well-loaded shallow drawer without strain.
• Ball bearing construction — hardened steel bearings in formed raceways deliver smooth, precise travel cycle after cycle.
• 1/2 to 5/8 inch drawer side compatibility — accepts the two most common drawer side thicknesses so the runner fits both standard and thinner box stock.

Where a 300mm Runner Belongs

At 300mm nominal length, this runner suits the shallower drawers in a kitchen or bath layout — spice inserts, inner drawer organizers, and narrow utility drawers that sit behind a deep face frame or in a compact base cabinet. Full extension means the back of the 300mm box comes fully out to the cabinet opening, which matters when the drawer is short and rear contents would otherwise stay out of reach. Frameless construction is the specified cabinet type, so the runner mounts directly to the flat interior panel without rear mounting brackets.

Build Quality and Finish

The Actro 5D runner is made from steel with a zinc finish, giving it the corrosion resistance needed for indoor cabinetry environments. Ball bearings run between formed steel raceways for consistent, low-friction travel — a more precise feel than nylon rollers, and better suited to drawers that cycle frequently. The integrated soft-close damper is part of the runner assembly, not a retrofit add-on, so the close is consistent without extra components.

Who Orders a Single Right-Hand Runner

Cabinet shops building frameless kitchens on CNC lines often order runners by hand to stock left and right members independently, then pair them per drawer count. Installers replacing a damaged member on an existing Actro 5D installation need the exact-hand replacement rather than a full pair. Designers specifying individual components for a custom drawer count also pull handed runners separately. In every case, this is the right-hand member — confirm the left-hand counterpart is on the same order to complete a working pair. The drawer box must be built to the Actro 5D's published specification, including the correct box width formula, rear notch, and locking-device drilling, before the runner will seat correctly.

The Right Member, Ready to Pair

When the 300mm Actro 5D right-hand runner is what the job calls for, this is the piece — full extension, integrated soft-close, and a zinc steel build sized for short frameless drawers. Add the left-hand member and the locking devices, build the box to spec, and the drawer is done.