Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Fulterer 5004 is a 14 inch over-travel side-mount ball bearing drawer slide in a zinc finish, rated 225 lb per pair with a hold-in detent that keeps the drawer closed until pulled. Built for heavy drawers that need to clear a countertop overhang or a deep face frame, this slide takes the load and the travel demands that standard cabinet slides can't meet.
The combination of over-travel and a 225 lb rating targets a specific drawer problem: a heavy box that needs to fully clear an obstruction at full open. Under a worktop overhang, behind a thick face frame, or in a shop cabinet where the drawer carries iron and steel, this slide delivers the reach and the load capacity together. The hold-in detent adds a practical benefit in any shop or garage setting — the drawer stays closed when bumped and doesn't drift open on an uneven floor.
Steel members throughout carry a zinc electroplate finish, the working standard for side-mount ball bearing slides used indoors. Zinc keeps rust at bay through the humidity cycles of a shop or utility room without adding the cost of a specialty coating. This is not a decorative finish — it is a functional, durable surface on a slide that will spend its life inside a cabinet.
Woodworking shops, garage cabinets, utility rooms, and any installation where a loaded drawer sits under a countertop or overhang will benefit from the over-travel action and the higher load class. It is also a sound choice for face-frame cabinet builds where the drawer needs extra travel to clear the frame at full open. The 3/4 inch side clearance per side is wider than the 1/2 inch standard — build the drawer box 1-1/2 inches narrower than the cabinet opening to accommodate it. In face-frame cabinets, rear mounting brackets are required; confirm the correct bracket series before ordering, as brackets are series-specific and sold separately.
Past full extension — the over-travel action carries the drawer member beyond the slide's 14 inch nominal length. The exact over-travel distance is not stated in the source data for this model; contact Fulterer or request the installation sheet for the precise travel figure.
Per pair. A single pair of these slides carries up to 225 lb, which is the number to compare against your loaded drawer weight.
No. The hold-in detent is a mechanical catch that holds the drawer closed and stops it from rebounding open. There is no damper and no spring assist — the drawer stays where you put it.
No. The design is non-handed, so both slides in the pair are the same part. Order the quantity equal to the number of drawers you are fitting.
3/4 inch per side — wider than the 1/2 inch clearance on standard cabinet ball bearing slides. Size the drawer box 1-1/2 inches narrower than the cabinet opening to leave the correct gap on each side.
When the drawer is heavy, the space is tight, and the load needs to clear an overhang every time it opens, the Fulterer 5004 in zinc has the capacity, the travel, and the hold-in detent to handle it reliably over the long haul.
Sold In: 8 Set
